These switches meet MIL-S-3950.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Choose an actuator and contact block to make your own 22 mm plastic switch.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Often used with machine guards, these switches mount to a door frame.

Plug monitors into relay sockets for fast installation and replacement.

These switches are housed in a protective enclosure so they can be mounted wherever needed.

Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, switch faster, and are quieter. They mount on 35 mm DIN rail (also known as DIN 3) for fast installation.

With no moving parts, these solid-state relays are fast switching and require less maintenance, last longer, and are quieter than mechanical switches.

Prevent damage from voltage spikes, reduce signal interference, and amplify signal with these relays, which interface between your controller and components to isolate input and output circuits.

Sealed for safety, these relays are a good choice for hazardous locations where combustible or corrosive gases may be present.

With a built-in web server, these relays can be remotely controlled over any IP network, including the Internet.

Often used for high-speed switching at low-current levels, these solid state relays have no moving parts, so they switch faster, last longer, and are quieter than mechanical switches.