Twist the sensor to detect metallic objects where explosive dust or gas may be present—the sensor rotates for front, side, top, or bottom sensing. These switches are UL and C-UL listed as well as ATEX and IECEx certified for hazardous locations.

With a smaller diameter and shorter length than standard sized switches, these fit in the most space-constrained areas.

Sense objects from farther away than with other DC proximity switches that have the same diameter.

These inductive proximity switches sense metallic objects each time they pass through the slot, even when they’re obscured by water, oil, dirt, or a surface finish. Use them to measure the speed of rotating equipment and to count or detect moving objects, such as sheet metal being fed into a stamping process.

Use these switches to sense metallic objects in environments containing flammable gases and combustible dust. ATEX and IECEx certified to protect against explosion, they produce a low-current, low-voltage NAMUR signal, so they won’t ignite or create sparks.

Sense objects as they pass through the switch’s ring via tubing or a funnel. These switches are often used to monitor blockages, detect breaks in spooling wire, or count small metallic parts, such as screws, during the stamping process.

Turn the face on these switches to sense metallic objects from the front, sides, top, or bottom.

Check the position of your torch or workpiece for accuracy during robotic welding.

For use in volatile areas, these intrinsically safe switches detect objects when they pass through the slot. They use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or create sparks. ATEX and IECEx certified, they protect against explosion.

Switches accept both AC and DC input voltage.

These switches have a longer sensing distance compared to other proximity switches with the same diameter.

Mount these flat inductive switches to a base or rail to remotely detect metallic objects in wet and dirty environments.

About half the size of standard photoelectric switches, these switches are good for use in tight spaces. They detect objects moving at high speeds with a light beam.

A built-in relay produces AC voltage output. These switches are often used with older programmable logic controllers (PLCs).

Rated IP69K, these switches can withstand high-pressure, high-temperature washdowns and temporary submersion.

Set these switches to delay activation by up to fifteen seconds after detecting an object.

Immediately cut power to machinery by breaking the light beam between two barriers.

Shut off machinery on your roughest, dirtiest job sites the second someone or something gets too close.

Detect objects as thin as a freshly sharpened pencil tip. These switches are best for tight spaces because they have a smaller light beam and can detect smaller objects than standard photoelectric switches.

Maintain sanitary standards—these switches have smooth surfaces without crevices, so they prevent bacteria from building up and are easy to clean.

These switches detect magnetic objects—or objects with a magnet attached—through non-magnetic walls.

Easily mount these flat switches to a base or rail.

These switches use a NAMUR signal to operate at a low current and voltage, so they won’t ignite or produce sparks. ATEX certified, they protect against explosion in environments containing flammable gases and combustible dust. Switches sense both metallic and nonmetallic objects.

These switches sense when a valve is open or closed, supporting flow and temperature control within your system and offering reliable feedback.

Wire contacts to an alarm system to alert when doors or windows are opened.

Use a free, downloadable app with these switches to automate alarms in your facility, such as sounding a buzzer if a trailer door is opened after a certain time.

Prevent unauthorized use—these switches require coded magnets to actuate. They cannot be bypassed using ordinary magnets.