Maximum Resistance Maximum Resistance |
|---|
|
|
Number of Turns Number of Turns |
|---|
|
System of Measurement System of Measurement |
|---|
|
Switching Current Switching Current | Show |
|---|
|
Switching Current Switching Current | Hide |
|---|
Number of Terminals Number of Terminals |
|---|
|
Switch Starting Position Switch Starting Position |
|---|
|
Shaft Diameter Shaft Diameter |
|---|
|
Housing Material Housing Material |
|---|
|
For Panel Cutout Diameter For Panel Cutout Diameter |
|---|
|
Diameter Diameter |
|---|
|
Wire Connection Type Wire Connection Type |
|---|
|
Environmental Rating Environmental Rating |
|---|
Wattage Wattage |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Input Voltage Input Voltage |
|---|
|
Height Height |
|---|
|
Shaft Length Shaft Length |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement)  |
|---|
Depth Behind Panel Depth Behind Panel |
|---|
|
Component Component |
|---|
|
Choosing a Proximity Switch
More
Light Beam Safety Barrier Switches
Immediately cut power to machinery by breaking the light beam between the two barriers. Light beams can travel up to 32 feet between the transmitter and receiver. For a complete system, combine a transmitter, receiver, safety relay, and connectors (sold separately). Switches will automatically produce PNP or NPN signal output based on the device they are connected to. To selectively allow material to pass through the sensing field, you can program the system to allow one or more beams to be broken without shutting off your machine.
Note: These switches cannot be used with a full-revolution clutch press or machine. Use only with machinery that can consistently and immediately stop anywhere in its cycle.
Use safety relays when connecting these barrier switches to emergency stop switches.
For technical drawings and 3-D models, click on a part number.
| Input Voltage | No. of Circuits Controlled | Switching Current @ Voltage | Industry Designation | Wire Connection Type | Ht. | Wd. | Dp. | Features | For DIN Rail Ht., mm | Each | |
| 24V DC | 2 | 2 A @ 240 V AC, 1.5 A @ 24 V DC | DPST-NO | Terminal Block | 4.9" | 0.69" | 4.3" | Auxiliary PNP Output | 35 | 0000000 | 0000000 |
| 24V DC | 4 | 2 A @ 240 V AC, 1.5 A @ 24 V DC | 4PST-NO | Terminal Block | 4.9" | 0.89" | 4.3" | Auxiliary PNP Output | 35 | 0000000 | 000000 |
Potentiometers
Vary electrical flow to control speed, volume, and light intensity. The number of turns affects the resolution—the higher the number, the better the control. Also known as variable output switches or rheostats. A knob is required (not included).