A rubber seal protects these switches from splashing water.

Able to withstand high currents, these switches are often used with motors and pumps.

The face of these switches mounts flush against a panel, so they're easy to clean and hard to damage.

Operate low-voltage devices that require less than 48 volts, such as doorbells and buzzers.

Use these switches where ignitable gas and dust may be present. They're rated for use in hazardous locations.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

These switches withstand temporary submersion.

Operate equipment from up to 330 feet away—these switches include a transmitter and a receiver that connects to equipment.

Apply pressure from any direction to actuate these switches.

Rated NEMA 4, these switches are protected from washdowns.

The lever sticks out further than a push button, making it easy to identify the position of these switches.

Smaller than standard size snap-acting switches, these fit in tight spaces.

Small enough to fit in the tiniest spaces, these switches are rated IP67 for protection from temporary submersion.

Often used on conveyor systems and bin filling operations, these switches have the rapid-closing action of a snap-acting switch but have a large actuator for sensing larger objects.

Protect machinery and ensure the safety of personnel—these switches will open the circuit when actuated even if a spring fails or the contacts stick.

Use these switches where ignitable gas and dust may be present. They meet NEC Class I, Divisions 1 and 2, Groups B, C, and D; and Class II, Divisions 1 and 2, Groups E, F, and G for hazardous locations.

Push and release the button to activate—no electricity required.

Use the mounting holes to attach monitors to a flat surface.

Thinner than other spade-terminal relays, these fit in tight spaces.

Attach quick-disconnect terminals or plug relays into relay sockets.

Built to handle tough, repetitive-use applications, these are more durable than standard relays.

A NEMA 4X enclosure protects the relay from washdowns, dirt, and corrosion. It has wire leads to hardwire to your equipment.

The interlocked opposing contacts won't close at the same time, so these relays are suitable for safety applications such as machine guarding.

The extended housing covers and protects terminals.

Split run time between two devices—this relay will automatically alternate between them.

Prevent voltage spikes from damaging your programmable logic controller or other sensitive control device. Thinner than other signal relays, these fit in tight spaces.

Plug these multifunction timer relays into relay sockets for fast installation and replacement.

Postpone starts longer and set wider intervals than with most timer relays.

A clear cover allows you to see if the switch is on or off.