We will reply to your message within an hour.
More
A rubber seal protects these switches from splashing water.
These switches meet MIL-S-3950.
Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.
Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.
Rated IP67, these switches are protected from temporary submersion.
These switches withstand temporary submersion.
Press these switches with your foot for convenient, hands-free operation.
Apply pressure from any direction to actuate these switches.
Rated NEMA 6P, 13, and IP68, these switches protect against corrosion, washdowns, and temporary submersion.
Use this switch for intermittent, light-duty applications.
When the pedal is pressed, the built-in potentiometer adjusts the resistance to vary the speed for motor drives.
Open and close circuits quickly to minimize arcing and prevent contacts from sticking. These switches are often used as door-open indicators on appliances and enclosures.
Smaller than standard size snap-acting switches, these fit in tight spaces.
Enclosures protect these snap-acting switches from the environment.
Rated NEMA 4 , these enclosed switches have a sealed actuator for protection from washdowns.
Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.
Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.
Prevent accidental activation—these switches require a key to turn lights on and off.
Often used as position indicators, pump level controls, and machine limit switches, these switches actuate when tilted to a certain angle.
Program these switches to turn a device on and off at a set time and day.
Designed to work with landscape and security lighting.
Switches fit single device (1 gang) outlet boxes.
Mount these switches to a flat surface or attach to DIN rail.
Install these switches in a panel cutout.
Use these switches in place of standard wall switches to automatically turn electrical equipment on or off after a set interval of time.
Install these switches in a panel cutout to automatically turn electrical equipment on or off after a set interval.
If there’s a power outage, flip the toggle for each circuit on these switches to backup power.
Using a low-current signal, these relays are often used to control small motors and heaters.
Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, switch faster, and are quieter. They mount on 35 mm DIN rail (also known as DIN 3) for fast installation.
For use with equipment that cycles on and off, these relays meet UL 508 for air conditioning and heating. Also known as definite-purpose contactors.
Also known as an air-to-electric switch, this relay converts an air signal to an electric signal.
Get NEMA 4 and IP66 protection from dirt and water. If vibration or shock exceeds a set activation point, the contacts actuate to either shut down your machine or activate an alarm.
These boxes come ready to use with receptacles and/or light switches installed.