The built-in contact block in these switches extends behind the panel half the depth of most other 22 mm switches, saving valuable space.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Use these switches where ignitable gas and dust may be present. Their contact blocks are UL listed for Class I, Division 2, Groups B, C, and D hazardous locations.

Immediately cut power with a single push.

Rated NEMA 4X and 13, all switches resist corrosion and can withstand washdowns and oil/coolant spraying.

Rated NEMA 3S, NEMA 4X, NEMA 13, and IP66, these plastic switches resist corrosion better than aluminum switches and withstand washdowns and oil/coolant spraying.

Mount these switches in an outlet box. Also known as palm-button switches, they have a large button that makes them easy to use even while wearing gloves.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

Switches are rated NEMA 4, 13, and IP66.

These plastic switches are rated NEMA 4X, 13, and IP65 for protection from corrosion, washdowns, and oil/coolant spraying. Install them in 30 mm dia. cutouts.

Rated NEMA 3S, 4X and 13, these switches are protected from corrosion, washdowns, and oil/coolant spraying.

Choose an actuator and contact block to make your own 30 mm switch.

Choose an actuator and contact block to make your own 16 mm switch.

Sized for 22 mm dia. panel cutouts, these switches require a key to turn circuits on or off, limiting access to sensitive equipment.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Pull the hanging rope in any direction to actuate these switches.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems. Equipment will not start up again until switch is manually reset.

Rated IP67, these switches are protected from temporary submersion. When an object in motion comes into contact with the actuator, it sends a signal to open or close a circuit.

Quickly and safely mount these relays on 35 mm DIN rail (also known as DIN 3). IP20 rated, they have recessed terminals that prevent fingers and other objects from touching live circuits.

Solder these relays directly to printed circuit boards using their solder pin terminals.

With no moving parts, these solid state relays last longer, switch faster, and are quieter than mechanical relays. They interface between your controller and components to isolate input and output circuits, which protects components from voltage spikes, amplifies the relay’s signal, and reduces interference for reliable transmission.