A rubber seal protects these switches from splashing water.

Maximize the space in a panel—these switches are half the size of most toggle switches.

Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

Simple to use, these switches actuate with a quick push.

Install in 12 mm dia. cutouts.

Install in 10 mm dia. cutouts.

Avoid accidental actuation—these switches won’t turn on or off until you grip and twist the lever. Install in a 16 mm dia. cutout.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Maximize space in a panel—these switches are smaller than most standard rocker switches.

Make or break an electrical circuit. These contact blocks mount to manual switches and transmit an electrical signal when the switch actuator is engaged.

Control machinery from a safe distance, or use these switches as call buttons.

Control multiple devices with one switch. Turn the shaft to change switch positions.

Apply pressure from any direction to actuate these switches.

Control equipment from up to 40 feet away—these switches include a transmitter and a receiver that connects to equipment.

Step on these switches for hands-free actuation in an area with frequent washdowns.

These switches are rated for environments where hazardous material is present.

Like turning on a flashlight, slide these switches from one side to the other.

Rated NEMA 4 or IP66, these switches are protected from washdowns.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems.

Built for tight spaces exposed to water, these switches have a housing that's less than 1" long and IP67 rated for protection from temporary submersion.

Actuate these switches with a fraction of the force of other subminiature switches for increased responsiveness. Among the smallest snap-acting switches we offer, they fit into the tiniest of spaces.

Stack these slim switches together, or fit them into tight spaces. They're rated IP67 for protection from temporary submersion.

Secure these switches into panel cutouts using mounting nuts. They have a slim body so they can also be stacked together or fit into tight spaces.

Install these switches in a panel cutout to automatically turn electrical equipment on or off after a set interval.