Thicker than standard safety switch mats, these can withstand repeated impact from heavy and sharp objects. They turn equipment off when stepped on or when a fault is detected, preventing personnel from getting too close to dangerous equipment when equipment is on. A complete switch requires a mat and a controller (sold separately). Together they meet ANSI/RIA R15.06 safety requirements. Mats are rated IP65 for protection from washdowns.

Optional frames secure mats to the floor. Punch holes in the frame to insert a screw anywhere along the length.

For technical drawings and 3-D models, click on a part number.

Rated IP67 and NEMA 6, these switch mats withstand washdowns and temporary submersion. They have a smaller footprint than other switch mats to fit in confined spaces.

With a smaller footprint than other switch mats, these fit in confined spaces.

At only 3/32" thick, these mats fit under carpeting or anywhere else you want to hide them.

Customize the length of these switches by cutting them from a 25-foot roll. The width cannot be cut. At only 3/32" thick, they fit under carpeting or anywhere else you want to hide them. Mats have bare wires that solder or crimp to a connector.

Step on these mats to control doors, lights, or alarms.

These narrow switches are also thin enough to be hidden under carpeting or installed anywhere space is limited. Actuate them anywhere along the length of the switch.

Optional mounting channels secure switches to a flat surface.

For technical drawings and 3-D models, click on a part number.

Customize the length of these switches by cutting them from a 50-foot roll. They're narrow and thin, so they can be hidden under carpeting or installed anywhere space is limited. Actuate them anywhere along the length of the switch. A complete system includes a strip switch and a termination kit (sold separately).

Optional mounting channels secure switches to a flat surface.

Use surface fillers for vinyl fabric (not included) to seal ends.

For technical drawings and 3-D models, click on a part number.

These switches actuate with the slightest push for a high degree of accuracy. All are rated IP67 for protection from wet locations and temporary submersion. They’re often used for determining manufacturing tolerances and detecting minute expansions and contractions.

For technical drawings and 3-D models, click on a part number.

These switches actuate with the slightest push for a high degree of accuracy. They’re often used for determining manufacturing tolerances and detecting minute expansions and contractions.

For technical drawings and 3-D models, click on a part number.

Sensitive along their entire length, these switches are often used to signal when an overhead door closes or an item reaches the end of a conveyor. The sealed housing protects against exposure to weather.

Optional mounting channels (sold separately) secure switches to walls or conveyors.

For technical drawings and 3-D models, click on a part number.

Use these switches in place of standard wall switches to automatically turn electrical equipment on or off after a set interval of time. They’re often used with lights.

Switches with override can bypass the automatic shut-off.

Set switches with beep and light signals to alert when the timer is almost done; the signals can also be turned off.

Switches with set time recall retain the last setting; hold the button down to restart the timer with that setting.

These relays switch through a series of different circuit configurations every time they receive an input voltage. The input voltage latches them in position, so they don’t require a constant voltage to stay switched. Use them to control motors, pumps, and lighting. The covered terminals prevent contact with live connections. Mount to 35 mm DIN rail. Also known as step relays.

For technical drawings and 3-D models, click on a part number.