A rubber seal protects these switches from splashing water.

Able to withstand high currents, these switches are often used with motors and pumps.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 14 mm dia. cutouts.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Rated IP67, these switches are protected from temporary submersion.

Choose an actuator and contact block to make your own 16 mm switch.

These 16 mm switches require a key to turn circuits on or off, limiting access to sensitive equipment.

Rated NEMA 6P, 13, and IP68, these switches protect against corrosion, washdowns, and temporary submersion.

When the pedal is pressed, the built-in potentiometer adjusts the resistance to vary the speed for motor drives.

Install these switches in a panel cutout.

Install these switches in a panel cutout to automatically turn electrical equipment on or off after a set interval.

Open or close a circuit when a fusible link melts. These switches are often used as a safety switch to shut off hydraulic equipment.

For use with equipment that cycles on and off, these relays meet UL 508 for air conditioning and heating. Also known as definite-purpose contactors.

With no moving parts, these solid state relays have an extended service life.

Use the mounting hole to attach these relays to a flat surface.

Use these switches for applications that need reliable switching but don’t require high accuracy.

Prevent changes to the set vacuum that powers equipment, activates controls, or signals alarms. The setpoint on these switches isn't adjustable.

Rated IP67, these connectors create a dust- and watertight seal where they fit into the housing of power supplies, appliances, and other electronic devices. Instead of hardwiring your devices, these connectors let you plug in a standard IEC power cord and turn the power on and off with a built-in switch.