Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.

Yellow zinc-plated steel is more corrosion resistant than nickel-plated steel.

Black-oxide steel has a dull shine for areas where appearance is a concern.

Made of 303/304 stainless steel, these mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

Black-oxide steel has a dull shine for areas where appearance is a concern.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

A hex nut at the base of the stud allows for easy height adjustment.

Use these mounts on heavy machines and equipment.

These mounts have a cushion on top to provide padding between your furniture and the mount.

All-stainless steel construction stands up to water and chemicals and won't rust or corrode.

Attach to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

The tip is narrow to pass through threaded holes.

These set screws have a low-profile flat-faced ball tip for use in low-clearance applications.

A wide tip provides more gripping power than standard swivel-tip thumb screws. To use, remove the tip, thread the screw through the hole, and attach the tip on the other side.

A large swivel angle allows these thumb screws to make better contact with angled and uneven surfaces than nonremovable swivel-tip thumb screws.

These stainless steel anchor studs offer excellent corrosion resistance.

A black-oxide finish provides mild corrosion resistance.