Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.

Choose these hoist rings when you need to lift your load from the side.

Unlike conventional eyebolts, you can rotate the eye 360° to match the angle of your load.

Attach to the end of a screw or threaded stud to apply uniform pressure on uneven and angled surfaces. Also known as toggle and swivel-foot pads.

Yellow zinc-plated steel is more corrosion resistant than nickel-plated steel.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Made of 303/304 stainless steel, these mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Made of 303 stainless steel, these mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

All-stainless steel construction stands up to water and chemicals and won't rust or corrode.

The tip is narrow to pass through threaded holes.

These set screws have a low-profile flat-faced ball tip for use in low-clearance applications.

A wide tip provides more gripping power than standard swivel-tip thumb screws. To use, remove the tip, thread the screw through the hole, and attach the tip on the other side.

A large swivel angle allows these thumb screws to make better contact with angled and uneven surfaces than nonremovable swivel-tip thumb screws.