Yellow zinc-plated steel is more corrosion resistant than nickel-plated steel.

Black-oxide steel has a dull shine for areas where appearance is a concern.

Made of 303/304 stainless steel, these mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

An offset mounting hole allows for installation without moving your machine.

An economical choice for applications in corrosive environments that don't require high load capacities, these mounts have a plastic base.

Made of 303 stainless steel, these mounts resist corrosion from water and most chemicals.

Punch-out holes in the base let you bolt down these mounts to keep your equipment stationary.

Often used on wobbly tables, these mounts automatically adjust up to 5/16" to compensate for uneven floors.

Meant for light duty applications, these mounts are not rated for capacity.

These mounts have a cushion on top to provide padding between your furniture and the mount.

Able to withstand temperatures up to 350° F, these have the highest maximum temperature of our plastic mounts.

All-stainless steel construction stands up to water and chemicals and won't rust or corrode.

Thread these mounts into machinery to level them on uneven floors in sanitary environments such as food-processing areas.

Higher deflection ratings translate to greater vibration and shock isolation.

Higher deflection ratings translate to greater vibration and shock isolation than our other vibration-damping leveling mounts.

The tip is narrow to pass through threaded holes.

These set screws have a low-profile flat-faced ball tip for use in low-clearance applications.

A wide tip provides more gripping power than standard swivel-tip thumb screws. To use, remove the tip, thread the screw through the hole, and attach the tip on the other side.

A large swivel angle allows these thumb screws to make better contact with angled and uneven surfaces than nonremovable swivel-tip thumb screws.