These blades have a heat-resistant coating to prevent material buildup.

Also known as dado-head blades, these are for cutting grooves in all types of wood.

Use these blades for occasional cutting.

A blend of tungsten carbide and diamond grits on the continuous edge of this blade cuts hard, nonmetallic materials including composites and graphite.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

A continuous edge on these blades produces smooth cuts.

The edge of the blade is segmented to cut faster than a continuous edge.

Use with water or coolant to produce smoother cuts in tile than dry-cutting blades. They're also for use on glass.

Make fast, clean cuts in steel sheets, angle iron, rebar, and pipe with the carbide teeth on these blades.

Diamond grit bonded to a segmented edge cuts through hard metal such as cast iron.

These blades have a heat-resistant coating to prevent material buildup.

Also known as dado-head blades, these are for cutting grooves in all types of wood.

Use these blades for occasional cutting.

Make clean cuts in rubber and plastic hose with the scalloped knife edge on these blades.

A razor-sharp knife edge minimizes dust and makes quick, clean cuts through foam sheets such as expanded polystyrene insulation and extruded polystyrene.

Use these blades with water or coolant to produce smoother cuts in tile than dry-cutting blades. They're also for use on glass.

The edge of the blade is segmented to cut faster than a continuous edge.

A continuous edge on these blades produces smooth cuts. It's coated in diamond grit to cut hard, abrasive materials such as masonry, stone, asphalt, and concrete.

Make fast, clean cuts in steel sheets, angle iron, rebar, and pipe with the carbide teeth on these blades.

Prevent clogging when cutting soft metal—these blades have plenty of space between the carbide-tipped teeth to allow chips to escape.

Cut plastic, wood, and soft metal such as aluminum, brass, and copper.

The segmented edge on these blades is coated with diamond grit for cutting plastic.

Use these titanium carbonitride (TiCN) coated blades on stainless steel.

These blades have a higher concentration of diamonds than other dry-cutting blades, so they last up to three times longer.