Weld these nuts to stainless steel surfaces.

Projections on the base concentrate the weld and provide room for heat to dissipate.

Use these metric nuts in channels and tight spaces where round-base weld nuts won't fit.

A smooth base provides more contact with the mating surface than weld nuts with projections.

Weld these nuts to stainless steel surfaces.

Square weld nuts have more weld points than hex weld nuts for a stronger hold. Use them on flat surfaces.

Weld these metric nuts to flat and uneven uncoated steel surfaces for a strong permanent hold.

You can weld these metric nuts to flat and uneven uncoated stainless steel surfaces for a strong permanent hold.

Threads float inside the retainer of these metric nuts so you can install a bolt at a slight angle to align with off center parts.

These adhesive-mount nuts have a zinc plating for corrosion resistance in wet environments.

These nuts have three mounting holes to accept screws and rivets for use with thin materials.

These studs have good chemical resistance. Weld them to stainless steel surfaces.

These stud anchors strengthen the parts of buildings where steel framing connects to concrete. They’re also known as Nelson studs.

Fasten these brackets to ceilings, walls, beams, and joists to hang threaded rod.

The two-piece design accommodates a wide range of panel thicknesses.

These brackets come in one piece that can be cut-to-size with a hacksaw.

Fit these brackets through drilled holes in panels.

Use four brackets to support the top and bottom edges of panels without drilling holes in them.

Lock these brackets together with a pin or a bolt. They are often used on marine docks.

Position proximity, photoelectric, and light beam sensors and switches.

Organize your index card files.