Clear All
    Taper End Style
    Taper End Style
    Show
    Ball End
    Taper End Style
    Taper End Style
    Hide
    Square End
    Ball End
    Taper Angle per Side
    Taper Angle per Side
    1 1/2°
    10°
    Cut Style
    Cut Style
    Tapered
    System of Measurement
    System of Measurement
    Inch
    Mill Diameter
    Mill Diameter
    default
    3/32"
    1/8"
    5/32"
    3/16"
    1/4"
    Length of Cut
    Length of Cut
    1/2"
    3/4"
    1"
    1 1/4"
    1 1/2"
    1 3/4"
    2"
    Shank Diameter
    Shank Diameter
    default
    1/4"
    3/8"
    1/2"
    Material
    Material
    Carbide
    Overall Length
    Overall Length
    3"
    3 1/2"
    4"
    Number of Flutes
    Number of Flutes
    3
    Number of Milling Ends
    Number of Milling Ends
    1
    Maximum Taper Diameter
    Maximum Taper Diameter
    1/4"
    3/8"
    1/2"
    End Mill Type
    End Mill Type
    Center Cutting
    Helix Angle
    Helix Angle
    28°
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Flute Type
    Flute Type
    Spiral
    Flute Spacing
    Flute Spacing
    Equal
    Individual/Set
    Individual/Set
    Individual
    Shank Type
    Shank Type
    Round
    Finish
    Finish
    Uncoated
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    20 Products

    Carbide Tapered Ball End Mills