Clear All
    Cut Style
    Cut Style
    SquareTapered
    Flat Surface
    Shank Type
    Shank Type
    RoundR8 Taper
    Taper Angle per Side
    Taper Angle per Side
    1/2°
    1 1/2°
    10°
    15°
    20°
    25°
    30°
    45°
    System of Measurement
    System of Measurement
    Inch
    Metric
    Taper End Style
    Taper End Style
    Square End
    Ball End
    Number of Flutes
    Number of Flutes
    34
    Number of Milling Ends
    Number of Milling Ends
    1
    End Mill Type
    End Mill Type
    Center Cutting
    Noncenter Cutting
    Flute Type
    Flute Type
    Spiral
    Flute Spacing
    Flute Spacing
    Equal
    Individual/Set
    Individual/Set
    Individual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Helix Angle
    Helix Angle
    28°
    Number of Inserts Required
    Number of Inserts Required
    1
    2
    3
    5
    Head Diameter
    Head Diameter
    2 1/2"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    197 Products