Pipe Size Pipe Size | Show |
|---|
Thread Type Thread Type | Show |
|---|
Flute Type Flute Type |
|---|
 | Straight |
Threads Per Inch Threads Per Inch |
|---|
|
Application Application |
|---|
|
Material Material |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Finish Finish |
|---|
|
Number of Tapping Ends Number of Tapping Ends |
|---|
|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
|---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
|---|
|
Shank Type Shank Type |
|---|
 | Square |
Thread Direction Thread Direction |
|---|
Individual/Set Individual/Set |
|---|
|
Overall Length Overall Length |
|---|
|
Long-Reach Pipe and Conduit Thread Taps
With an extra-long shank, these taps have extended reach for tapping deep and hard-to-reach areas in pipe and conduit. They're made of high-speed steel and are for use on most metal and plastic. The square shank is compatible with tap wrenches and tap holders for drill presses and milling machines.
Bottoming-chamfer taps cut into the workpiece with just 1-2 chamfered threads. This short chamfer lets them thread holes closer to the bottom than other taps, but they require more torque to start threads.
For technical drawings and 3-D models, click on a part number.
Drill Bit | Bottoming Chamfer | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| Pipe Size | Thread Type | Threads Per Inch | Thread Lg. | Overall Lg. | Size | Decimal Size Equivalent | No. of Flutes | Each | |
Uncoated High-Speed Steel | |||||||||
| 3 | NPT | 8 | 2 5/8" | 6" | 3 15/64" | 3.2344" | 7 | 0000000 | 0000000 |
Economy Carbon Steel Pipe and Conduit Thread Taps
Use these carbon steel taps for thread repair and occasional tapping of pipe and conduit. They can tap threads into most metal and plastic, but they have a shorter tool life than standard taps. With a square shank, they're compatible with tap wrenches and tap holders for drill presses and milling machines. All have a plug chamfer with 3-5 chamfered cutting threads, so they're suitable for start-to-finish tapping. When using them to tap closed-end holes, be sure to leave sufficient space at the bottom for chips to accumulate.
For technical drawings and 3-D models, click on a part number.
Drill Bit | Plug Chamfer | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| Pipe Size | Thread Type | Threads Per Inch | Thread Lg. | Overall Lg. | Size | Decimal Size Equivalent | No. of Flutes | Each | |
Uncoated Carbon Steel | |||||||||
| 3 | NPT | 8 | 2 3/4" | 6" | 3 1/4" | 3.25" | 8 | 000000000 | 000000000 |