System of Measurement System of Measurement |
|---|
|
Thread Size Thread Size | Show |
|---|
Thread Size Thread Size | Hide |
|---|
Threading Threading |
|---|
|
Material Material |
|---|
|
Finish Finish |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Thread Fit Thread Fit |
|---|
|
For Hole Diameter For Hole Diameter |
|---|
|
Collar Diameter Collar Diameter |
|---|
|
Thread Type Thread Type |
|---|
Thread Spacing Thread Spacing |
|---|
Thread Direction Thread Direction |
|---|
 | |
Base Length Base Length |
|---|
|
For Lathe Chuck Diameter For Lathe Chuck Diameter |
|---|
|
About Nuts, Materials, and Finishes
More
Square Weld Nuts
Square weld nuts have more weld points than hex weld nuts for a stronger hold. Weld them on flat uncoated steel surfaces. All have a collar pilot that assists alignment and prevents welding spatter from getting into threads.
For technical drawings and 3-D models, click on a part number.
Collar | ||||||||
|---|---|---|---|---|---|---|---|---|
| Thread Size | Wd. | Ht. | Dia. | Ht. | For Hole Dia. | Pkg. Qty. | Pkg. | |
Steel | ||||||||
| 7/16"-14 | 3/4" | 5/16" | 21/32" | 0.063" | 43/64" | 25 | 000000000 | 00000 |
Steel Hex Weld Nuts
Weld these nuts to flat and uneven uncoated steel surfaces for a strong permanent hold. A collar pilot assists alignment and prevents welding spatter from getting into threads.
For technical drawings and 3-D models, click on a part number.
Collar | ||||||||
|---|---|---|---|---|---|---|---|---|
| Thread Size | Wd. | Ht. | Dia. | Ht. | For Hole Dia. | Pkg. Qty. | Pkg. | |
Steel | ||||||||
| 7/16"-14 | 3/4" | 21/64" | 21/32" | 0.05" | 43/64" | 25 | 000000000 | 000000 |
T-Slot Nuts
Designed to slide into T-slot tracks on machine tool tables, use these nuts to secure clamps and workpieces.
Fully threaded nuts allow a stud to extend beyond the bottom of the nut. Partially threaded nuts keep studs from traveling past the bottom of the nut and damaging your table.
For technical drawings and 3-D models, click on a part number.
Lathe Chuck Jaw Nuts
Secure jaws to a CNC lathe chuck with industry standard 1.5 mm × 60° serrations or wider 3 mm × 60° serrations.
Jaw nuts with inch and M14 threads fit most chucks made by Matsumoto.
For technical drawings and 3-D models, click on a part number.
Base | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| For Lathe Chuck Dia. | For Slot Wd. | Thread Size | Ht. | Lg. | Wd. | Overall Ht. | For Serration Size | Mounting Hole Ctr.-to-Ctr. | Material | Each | |
| 8" | 0.551" | 7/16"-14 | 21/64" | 1 3/4" | 51/64" | 7/8" | 1.5 mm × 60° | 0.984" | Steel | 0000000 | 000000 |