A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

Hang a string of lights overhead to brighten wet jobsites. IP rated, these lights are sealed to keep out dust and moisture from washdowns, splashes, and sprays, even outdoors.

A flexible design allows these lights to be suspended above, wrapped around, or routed through areas on the job site.

Hang these lights above your workspace—they shine through long tubes to distribute even light with minimal glare and shadows. Carry them where you need them and suspend them from pipes, beams, and other overhead surfaces.

Pop these lights on magnetic surfaces to brighten wet spaces. Rated NEMA 6 and ETL listed, you can splash, spray, or dunk them in water, and they’ll keep working.

Power these lights with the same battery as your other cordless tools. They run on a Milwaukee M18 battery to light up work where there’s no outlet.

Aim light where it's needed most in areas that don't have an electrical outlet.

From pipes to pallet racks to control panels—these lights clamp onto almost anything and swivel to direct light just where you need it.

Splashes and drips are no problem for these lights. They don’t need an outlet, so you can bring them wherever you need them.

Aim light where you need it—even in explosion-prone spaces—by raising, lowering, and tilting these lights on their tripod. Rated NEC Classes I, II, III, and Zone 0, they’re safe to use near ignitable concentrations of flammable or combustible gas, dust, or fibers.

Bring light to explosion-prone work areas. Rated NEC Class I, these lights are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust, these lights are rated NEC Class I, Class II, and Zone 1.

Bring light to remote areas with the DeWalt rechargeable battery that's already in your toolkit.

Brighten remote areas, even if they’re damp or rainy. These floodlights are IP rated to keep out humidity and dripping, splashing, and falling liquids.

With a rounded, weighted base, these floodlights wobble—but don't fall over—when bumped.

Bring light to remote, wet areas. These floodlights are IP rated to handle humidity and dripping, splashing, and falling liquids. Adjust their tripod up and down to direct light as far as you need.

Light up remote spaces without having to keep track of a new cordless tool battery. These floodlights run on a Milwaukee M18 battery (sold separately). These lights extend up to 7 ft. tall and have a pivoting head to direct light where you need it.

Our brightest plug-in floodlights, these lights illuminate large worksites—about the size of a hockey rink.

Provide 360° of lighting.

Gently bend these single-use lightsticks to activate.

Plug in these flashlights and they’ll automatically light up when the power goes out. There’s no need to regularly replace the batteries—they recharge on the base when it’s plugged into an outlet.

If the power goes out, you’ll find these flashlights right away.

Always have a flashlight on hand—these attach to a key ring.

The handle opens into a tripod, so you can shine light on your work while keeping your hands free.

At full power, these flashlights shine as bright as a stadium light. They’re the brightest in our offering.

Light up objects more than a quarter of a mile away. These flashlights are also known as searchlights.

These flashlights are built to handle everyday use. They have a slip-resistant grip to ensure a secure hold.

Shine light into hard-to-reach spaces—these flashlights have a flexible arm to see around tight corners and in crevices. They’re rated for use in environments where flammable gases, vapors, and liquids are present.

Clip these little flashlights to any surface up to 1/2” thick and keep your hands free for work. They’re rated for use in environments where ignitable concentrations of flammable or combustible gases, vapors, and liquids are present.

Tilt the head on these flashlights to point light where you need it in explosion-prone areas. Rated NEC Classes I and II, they’re safe to use where there are ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust.

All of these flashlights stand up to wet environments.

Light up your work from under your brim.

Light that moves with your gaze, not your grip. These headlamps provide hands-free illumination.

Brighten things in your periphery without having to turn your head. These headlamps cast a beam that’s two to three times wider than traditional headlamps.

Clip these headlamps right into a mount on your tactical or rescue helmet.

Wear a flashlight around your neck to keep your hands free.

These lights are sealed to withstand shallow water, such as ponds and fountains.

Attach tools with a magnet to glass, aluminum, and other nonmagnetic surfaces. Often used to hang portable lights, these mounts have a steel plate on one side and a suction cup on the other.