A nonreflective black oxide finish prevents glare that can interfere with machine vision systems.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

Push the lever to lock the handle and prevent accidental opening.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Push the lever to lock the handle and prevent accidental opening.

Hold workpieces of different thicknesses without adjustment.

Two sets of mounting holes allow mounting on the bottom or side.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Mount these clamps below a surface.

Replace worn screws or customize your clamps.

Attach one of these nonmarring rubber or plastic tips to prevent a metal holding screw from damaging workpiece surfaces.

Push the lever to lock the handle and prevent accidental opening.

Push the lever to lock the handle and prevent accidental opening.

Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Moving parts are sealed to prevent dirt and dust from clogging the clamp.

Secure these clamps to a rail or bar.

Push the lever to lock the handle and prevent accidental opening.

For repetitive clamping, turn the holding screw to adjust the opening size one time, and then use the handle to secure and release workpieces.

Mount using the holes in the base.

Not as bulky as our other constant-tension clamps, these round-wire clamps easily fit in cramped spaces. Use in low-pressure applications.

Don't worry about your hose and tube expanding and contracting when temperatures fluctuate—these clamps have a Bellville spring that automatically increases and decreases the clamp's diameter.

Slotted on both ends for installation with a screwdriver.

A flange keeps the plunger from being pushed through a hole when the ball is depressed.

Noses are up to four times longer than standard long-nose press-fit spring plungers.

Lock the nose into the retracted position by pulling the handle and rotating it 90°.

Install by hand or with a hex key in low-clearance applications.

Thread onto machinery or attach a knob or handle to the threaded spindle.

Lock the nose into the retracted position by pulling the ring and rotating it 90°.

The ring allows you to attach these spring plungers to a lanyard.

A quarter turn of the handle locks these plungers in the retracted position. The T-handle is easy to grip.

An L-handle takes up less space than a T-handle.

Add a knob or handle to the threaded shank.

Two holes in the plate allow these plungers to be mounted to a flat surface.

Install with a hex key for more torque than slotted ball-nose spring plungers.

An O-ring in the flange creates a tight seal.

Weld these catches in place for a strong permanent hold.