Lubricate, clean, deoxidize, and prevent corrosion on electrical contacts to improve their performance.

NLGI viscosity grade is a rating of a grease's consistency. NLGI 2 is about the consistency of peanut butter.

Grease with quartz has quartz particles to assist oxide breakup. Grease with copper has copper particles to assist oxidize breakup and resist abrasion on surfaces that require conductivity. Grease with aluminum is for use on aluminum parts that won’t come in contact with each other. Grease with graphite has graphite particles to absorb and dissipate heat. Grease with only deoxidizer provides the best lubrication and is for use on clean surfaces.

Grease lubricates most efficiently within the listed temperature range. Melting temperature is the point at which grease will fail and run out of equipment, leaving it to run dry.

A high silver content gives this grease excellent conductivity for applications where electricity and heat transfer are required. It is suitable for ESD (electrostatic discharge) and EMI (electromagnetic interference) shielding applications.

NLGI viscosity grade is a rating of a grease's consistency. NLGI 2 is about the consistency of peanut butter.

Electrical resistivity is a measure of how well a material opposes the flow of electricity. The lower the rating, the more electricity it conducts.

Thermal conductivity measures a material’s ability to transfer heat. The higher the rating, the more heat it transfers.

Grease lubricates most efficiently within the listed temperature range. Melting temperature is the point at which grease will fail and run out of equipment, leaving it to run dry.

Copper allows these lubricants to conduct electricity, while graphite gives them good chemical and corrosion resistance. Also known as thread lubricants, antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

Loctite® C5-A Copper-Based Anti-Seize lubricants can be used with salt water and petroleum-based chemicals. LB 8065 comes as a stick for no-mess application.

Lubricants that meet MIL-A-907F and MIL-PRF-907F have been tested to prevent corrosion of copper and for antiseize properties when used with steel nuts and studs.

Dielectric strength measures the maximum voltage a lubricant can withstand without losing its insulating properties. The higher the dielectric strength, the better its quality as an insulator.

Electrical resistivity is a measure of how well a material opposes the flow of electricity. The lower the rating, the more electricity it conducts.

Protect electrical components—these lubricants insulate and block moisture, preventing electrical malfunctions. They cut through dirt, grease, and rust to clean connections and relays, leaving behind a thin film for long-lasting protection.

Dielectric strength measures the maximum voltage a lubricant can withstand without losing its insulating properties. The higher the dielectric strength, the better its quality as an insulator.

These lubricants cannot be sold outside of the United States due to product labeling requirements.

Bond heat sinks to surfaces, eliminating air gaps for maximum heat transfer. These compounds are commonly used with transistors, diodes, rectifiers, and transformers.

Zinc oxide compounds create a more secure bond than silicone compounds.

Also known as thermal paste, these boron-nitride compounds increase heat transfer between parts while preventing them from sticking. Unlike antiseize compounds, they don't conduct electricity, so you won't risk shorting out sensitive electronics. They're often used on thermocouple probes to improve accuracy. You can also use them in 3D printer heating blocks and other high-temperature areas to keep parts from fusing together.