Use these dies to create external threads on bolts, studs, and rods.

The teeth on these high-speed steel dies are designed to cut through stainless steel.

Cut threads in PVC with the specially designed teeth on these high-speed steel dies.

Connect to a compatible ratchet or electric threader to cut external pipe and conduit threads.

Each set includes a ratchet with handle, die heads, and dies. Use them to cut NPT threads in steel pipe and conduit by hand.

Use with Ridgid Electric Pipe and Conduit Threaders and Ridgid Hand-Held Electric Pipe and Conduit Threaders to thread pipe and conduit sizes of 2-1/2, 3, 3-1/2, and 4.

These machines thread faster than the Ridgid 300 and include a self-lubricating die head and automatic chuck.

Restore rusted and damaged screw threads. These dies are hex shaped for use with conventional wrenches.

A smaller width than standard hex dies lets you repair threads in tight spaces.

These dies open to wrap around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod.

Clean and restore the fine threads on power transmission shafts that are used with bearing locknuts. Dies are sized according to the American Bearing Manufacturer's Association (ABMA).

Repair rusted and damaged threads on any diameter bolt, stud, or rod.

Six files and four handles are included in these sets.

Slide over the end of threaded rod, pipe, and conduit to the area where threads are damaged, then tighten and rotate to repair threads.

Also known as die stocks, these wrenches grip round dies so you can turn them by hand.