Also known as nut eyebolts, these are designed for through-hole applications.

Route wire and cable through the smooth eye without snagging.

The matte black-oxide finish won't reflect light, allowing the eyebolts to blend into the background.

Use these eyebolts for routing wire and for other light duty applications.

Also known as thimble eyebolts, the large, contoured groove in the eye reduces kinks and minimizes the wear on your wire rope.

Choose these hoist rings when you need to lift your load from the side.

The fixed base provides added stability and allows you to lift heavy loads with smaller thread sizes.

Use for three-sided connections. Flat sides ensure webbing and strapping lay flat, so they won't slide and bunch.

Flat sides allow webbing and strapping to lay flat, so they won't slide and bunch.

A smaller width than standard hex dies lets you repair threads in tight spaces.

Clamp these dies around your workpiece, so you can start thread repair anywhere along the length of a bolt, stud, or rod. They're hex shaped for use with conventional wrenches.

Repair the broad, square threads on Acme threaded studs and rods. These dies are for general purpose Acme threads with a Class 2G thread fit.

Clean and restore the fine threads on power transmission shafts that are used with bearing locknuts. Dies are sized according to the American Bearing Manufacturer's Association (ABMA).

Slide over the end of threaded rod, pipe, and conduit to the area where threads are damaged, then tighten and rotate to repair threads.

Cut left-hand external threads on bolts, studs, and rods.

Use these dies with Ridgid pipe and conduit threader die heads on Ridgid pipe and conduit threaders.

Use these dies with Ridgid pipe and conduit threader die heads on Ridgid pipe and conduit threaders.

Carry this pipe and conduit threader to your work site.

Connect to a compatible ratchet or electric threader to cut external pipe and conduit threads.

Cut threads in PVC with the specially designed teeth on these high-speed steel dies.

Add or replace parts such as drive adapters, die sets, and drive bars for the Ridgid Large Size Pipe and Conduit Threader Adapter.

Convert round dies to hex dies for use with a conventional wrench.

Use a single set for many sizes of internal and external threads. All sets include tap and die wrenches.

Switch from internal to external threading with interchangeable tap and die adapters. Use them with the included ratcheting wrench.

Renew external threads in a wide range of sizes. The dies in these sets have a narrower width than standard dies, making them a good choice for thread repair in tight spots.

Cut several sizes of external screw threads.

These nuts have a black-oxide finish for mild corrosion resistance in dry environments.

These steel panel nuts are zinc plated for corrosion resistance.

Brass panel nuts are corrosion resistant in wet environments and electrically conductive.

Press these metric nuts into a drilled or punched hole with an arbor press or similar pressure tool.

These nuts have good chemical resistance and may be mildly magnetic.

A flat hex head sits flush against the material surface for use in low-clearance applications.

Stainless steel press-fit nuts have excellent corrosion resistance in most environments.

Also known as broach style captive nuts, these metric nuts have good chemical resistance and may be mildly magnetic.

These tools include everything you need to install press-fit nuts by hand.

Secure threaded plastic conduit fittings to a knockout in an outlet box or enclosure.

Includes a black, blue, green, purple, and red tag ring.

Use these fittings in extreme-pressure conditions up to 15,000 psi.

Use these fittings in low-pressure flow applications. They have good corrosion resistance.

In addition to being lightweight, these aluminum fittings offer good corrosion resistance. Use them in low-pressure flow applications.