We will reply to your message within an hour.
More
Comparable to Grade 8 steel, these threaded rods have a tensile strength of 150,000 psi, making them about 25% stronger than medium-strength steel rods.
Grade B7, these threaded rods have a tensile strength about one and a half times stronger than low-strength steel rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. Made from Grade B7 steel, their tensile strength is one and a half times higher than low-strength steel rods.
Grade B16 threaded rods maintain their strength at higher temperatures than Grade B7 threaded rods. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
About half the strength of medium-strength steel threaded rods, use these for light duty hanging, mounting, and fastening.
Tighten these threaded rods by turning them to the left; once fastened, they resist loosening from counterclockwise motion. About half the strength of medium-strength steel threaded rods, use them for light duty hanging, mounting, and fastening.
18-8 stainless steel threaded rods have good chemical resistance.
Grade B8 threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges. They have good chemical resistance.
Stronger and more wear resistant than 18-8 stainless steel, these threaded rods are mildly chemical resistant. They meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
More corrosion resistant than 18-8 and 410 stainless steel threaded rods, these 316 stainless steel rods have excellent resistance to chemicals and salt water.
Grade B8M threaded rods meet the pressure and temperature requirements of ASTM A193 and are often used to secure pressure tanks, valves, and flanges.
Brass threaded rods are corrosion resistant in wet environments, electrically conductive, and nonmagnetic.
Known as setup studs, these studs withstand sideways forces better than fully threaded studs because they have a strong unthreaded middle.
Also known as tap-end, fixture, and setup studs, these studs have Class 5 friction-fit threads on one end to resist loosening and Class 2A standard threads on the other end for attaching a nut.
Screw these studs into a tapped hole and use them as a pivot point, hinge, shaft, or locator pin.
Made from Grade 8 steel, these nuts are about 25% stronger than medium-strength steel coupling nuts. Furnished in inch thread sizes.
About half the strength of medium-strength steel coupling nuts, these nuts are for light duty fastening applications.
The left-hand threads on these coupling nuts resists loosening from counterclockwise vibration. Use in light duty applications.
Made from Grade 5 steel, these inch-sized coupling nuts are suitable for most applications.
Comparable in strength to Grade 9 bolts, these coupling nuts are about 20% stronger than high-strength steel coupling nuts. Available in inch thread sizes.
These coupling nuts have good chemical resistance.
More corrosion resistant than 18-8 stainless steel coupling nuts, these nuts have excellent resistance to chemicals and salt water.
One-third the weight of steel, aluminum coupling nuts resist corrosion in wet environments.
Brass coupling nuts are corrosion resistant in wet environments and electrically conductive.
Known for their strength, steel coupling nuts are available with a corrosion-resistant finish.
Connect two differently sized male-threaded parts, such as threaded rods, and tighten with a standard wrench.
Often called sleeve nuts, these thread adapters fasten parts with right-hand threads to parts with left-hand threads.
Mount the flange to a machine or wall to support idler sprockets and pulleys in tensioning applications. They include washers and a nut to position your component and hold it in place.