The handles are angled 90° from the blade so you can cut material from directly above in tight spaces. Also known as aviation snips, these cutters have a double hinge that provides high cutting force with low gripping pressure. A spring opens the jaws for quick cutting, and a locking latch holds them together when the cutter is not in use. Blades are serrated to prevent slipping.

This cutter has two blades that cut a 13/64" wide strip—peel it back for smooth edges with little distortion. Also known as aviation snips, this cutter has a double hinge that provides high cutting force with low gripping pressure. A spring opens the jaws for quick cutting, and a locking latch holds them together when the cutter is not in use.

Prevent waste from flying up as you work. A double blade makes two cuts, creating a 7/64" wide strip that peels back leaving little distortion and smooth edges. Also known as aviation snips, these cutters have a double hinge that provides high cutting force with low gripping pressure. A spring opens the jaws for quick cutting, and a locking latch holds them together when the cutter is not in use. The serrated blade edge prevents slipping.

Also known as tinners' snips, these cutters make straight cuts and curves. Blades are heat treated then sharpened for increased performance and durability.

Also known as bulldog snips, these have long handles and short blades for cutting heavy material in any direction.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Replace blades as they wear. These cutters are also known as tinners' snips.

Made of aluminum-bronze, the handle and blade on these cutters inhibit sparking and are FM approved. Use them for straight cuts. They're also known as tinners' snips. They help meet OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present. Warning: Do not use these tools in direct contact with acetylene due to the possible risk of explosion.

Make cuts in metal up to 1/32" thick with these compact cutters.

Make round, square, and irregular-shaped holes with this punch-style hole cutter. Drill a 7/16" dia. starting hole, then push the cutter through the hole and squeeze the handles together to cut out small pieces of material.

Turn your portable drill into a punch cutter for cutting curved and straight shapes in flat and corrugated sheet metal and plastic. To start cuts in the center of material, drill a starting hole.

Punch small pieces out of material to create an almost burr-free cut with no material distortion. To start cuts in the center of material, drill a starting hole.

Style D can also cut aluminum with the punch, die, and stripper for use on aluminum (sold separately).

Nibblers that comply with OSHA 29 CFR 1910.243 meet standards for hand-held equipment. Nibblers that meet OSHA Compliant 29 CFR 1926.302 fulfill requirements for power-operated hand tools.

These nibblers punch small pieces out of material to create an almost burr-free cut with no material distortion. To start cuts in the center of material, drill a starting hole.