Search Results
    Cut Direction
    Cut Direction
    Right Hand
    Left Hand
    Neutral
    Shank Width
    Shank Width
    5/8"
    3/4"
    1"
    Shank Height
    Shank Height
    5/8"
    3/4"
    1"
    For Insert Inscribed Circle Diameter (IC)
    For Insert Inscribed
    Circle Diameter (IC)
    default
    3/8"
    1/2"
    Holder Code
    Holder Code
    MTAN
    MTEN
    MTGN
    MTJN
    DTGN
    For Insert Thickness
    For Insert Thickness
    1/8"
    3/16"
    Back Rake Angle
    Back Rake Angle
    default
    -10°
    -7°
    -5°
    End Cutting Edge Angle
    End Cutting Edge Angle
    default
    15°
    27°
    60°
    Overall Length
    Overall Length
    4 1/2"
    6"
    Clamp Reference Number
    Clamp Reference Number
    CL-6
    CL-9
    CM234R ASSY
    Lock Pin Screw Reference Number
    Lock Pin Screw
    Reference Number
    NL-34L
    NL-46
    Seat Reference Number
    Seat Reference Number
    ITSN-333
    ITSN-433
    ITSN-443
    Insert Holding Method
    Insert Holding Method
    Clamp with Lock Pin Screw
    Wedge Clamp
    Shank Style
    Shank Style
    Straight
    Offset
    Side Cutting Edge Angle
    Side Cutting Edge Angle
    default
    30°
    -3°
    End Relief Angle
    End Relief Angle
    default
    Side Rake Angle
    Side Rake Angle
    default
    -7°
    -5°
    Side Relief Angle
    Side Relief Angle
    default
    Clamp Screw Hex Key Size
    Clamp Screw Hex Key Size
    5/64"
    3/32"
    Clamp Screw Reference Number
    Clamp Screw
    Reference Number
    XNS-36
    XNS-59
    XNS-510
    XNS-48
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)

    54 Products