Prevent sewer gas from entering your building. Traps swivel and adjust vertically for convenient installation.

Loosen the knobs on these J-bends to clean them out without removing them from your pipe system.

Use these extensions to help connect drain tailpieces to drain traps.

This drain is chemical resistant and often used in lab sinks. The P-trap prevents vapors from returning up through the drain.

These adapters connect sink drain traps to threaded wall and floor drain outlets.

Use these fittings to connect tailpieces, P-traps, S-traps, and extension tubing to sink drains.

Also known as inverted-bucket steam traps, these provide near-continuous discharge to accommodate high condensate levels.

Also known as thermodynamic steam traps, these discharge condensate when close to steam temperature for minimal energy loss.

Also known as thermostatic steam traps, these increase the efficiency of your radiator by venting cool air.

Suitable for food, pharmaceutical, and other sanitary environments, these steam traps are made of 316 stainless steel with a Viton® fluoroelastomer O-ring to stand up to frequent washdowns with harsh cleaners and sanitizers.

Improve vacuum system efficiency and protect components from moisture—these separators remove over 90% of water from air.

To keep airborne oil and odor out of your work environment, connect these filters to your high-vacuum oil pump. They purify pump exhaust in two stages: a fiberglass layer captures oil and collects it into a drain, and an active carbon layer removes any odor-causing oil or chemical vapors.

Capture oil, oil vapor, and other contaminants from your pump to prevent them from spreading into your high-vacuum system.

A drawstring at the opening allows you to tie these filter bags directly to your pipe or hose.

Use with a filter bag housing.

Remove contaminants, moisture, and other particles from steam that will touch food and for final filtering in pharmaceutical, biotech, and electronics applications.

Remove foreign particles from food and other sanitary material with these magnetic filters.

The guide rods direct flow to the magnetic rods. They’re helpful in removing dry particles from fine powder and low-flow applications.

Keep coolant systems free of small particles, such as chip filings and metal dust.

A spring-loaded bar snaps down when the trip is touched.

Bait these traps once and catch up to 30 mice. The lid is hinged, offering access for releasing and discarding.

These plastic stations have a semi-clear lid to check the poison.

Place along walls to trap insects on the sticky surface.

Wipe out colonies of ants when a few take bait back to the rest.

These Schedule 40 fittings are the industry standard for gravity-flow drain, waste, and vent (DWV) applications.

These fittings are NSF certified for use in corrosive waste gravity-flow systems. Made of CPVC, they have better chemical resistance than ABS plastic gravity-flow fittings and can stand up to highly-corrosive acids and other harsh substances.

A float-operated drain valve on these separators automatically opens when the bowl begins to fill. The first step in water removal, use one of these separators to remove the large amount of water as compressed air cools.

In addition to removing large amounts of water, these separators also remove particles and oil droplets. Place them after your compressor and aftercooler, or at the point of use in applications that don't require an aftercooler.

Form a barrier to stop small spills from spreading on tabletops and workstations with these flexible rubber dikes.

Create a barrier to stop spills from spreading. Dikes bend to form almost any shape you need. They resist oil, water, and most chemicals, and are nonabsorbent, washable, and reusable.