Clear All
    For Use On
    For Use On
    Show
    Stainless Steel
    For Use On
    For Use On
    Hide
    Warning: Products have one, but not necessarily all, of the selected characteristics.
    Copper
    Brass
    Steel
    Stainless
    Steel
    Aluminum
    Titanium
    Plastic
    System of Measurement
    System of Measurement
    Inch
    Metric
    Material
    Material
    Steel
    Aluminum
    Iron
    Maximum Bending Angle
    Maximum Bending Angle
    90°
    180°
    Mandrel Material
    Mandrel Material
    Steel
    Iron
    Iron/Aluminum
    Power Source
    Power Source
    Manual
    DFARS (Defense Acquisition Regulations Supplement)
    DFARS (Defense Acquisition
    Regulations Supplement)
    Mounting Location
    Mounting Location
    Bench Top
    Vise
    For Maximum Flat Stock Thickness
    For Maximum Flat
    Stock Thickness
    1/8"
    1/4"
    For Maximum Rod Diameter
    For Maximum Rod Diameter
    5/16"
    1/2"
    For Maximum Wire Diameter
    For Maximum Wire Diameter
    5/16"
    1/2"
    Number of Mounting Holes
    Number of Mounting Holes
    2
    3
    Mounting Hole Diameter
    Mounting Hole Diameter
    5/16"
    3/8"
    9/16"
    Die Diameter
    Die Diameter
    3/4"
    1 1/4"
    1 5/8"
    For Maximum Flat Stock Width
    For Maximum Flat Stock Width
    1"
    Height
    Height
    3 1/2"
    5"
    6"
    10"
    For Copper Tubing Type
    For Copper Tubing Type
    K
    L
    Handle Length
    Handle Length
    12"
    36"
    Enter e-mail addresses in the fields below
    Message
    Cancel
    Comments
    E-mail address (if you would like a response)
    48 Products