Choose the width you need from 6" to 60" in 1/16" increments.

Choose the width you need from 6" to 60" in 1/16" increments.

Improve tracking on curved conveyor sections. Rollers taper so packages maintain their orientation through the curve.

Rollers move in one direction so they won't roll back when idle, keeping packages in place.

Rollers have a standard 1.9" diameter to fit most roller conveyors.

We'll get the between frame width and groove spacing you need in 1/16" increments.

Connect to other rollers with two grooves to power a gravity conveyor or build a custom powered conveyor.

Replace rollers on a chain-driven conveyor.

Sleeve bearings ride directly on the axle and have no moving parts to wear out.

Use these bearings to replace worn and damaged bearings or press-fit them into tubing or pipe create a roller. All have a hex-shaped axle.

Clips clamp onto the shaft to keep spools from slipping, preventing wear on the belt.

Reduce noise, absorb impact, and extend roller life.

Mount to a conveyor frame to recondition a worn hex axle hole or to convert a round axle hole to a hex axle hole.

Add a package stop on a conveyor to control product flow and allow for accumulation.

These tools include one slide bar and 10 bending mandrels for 1/4" to 5/8" tube OD.

Use one hand to make bends up to 90° in soft metal tubing.

Smoothly bend hard metal tubes, such as steel and titanium, without causing crimps or kinks.

Protect thin-wall tubing from crimping and collapsing while bending by hand.

Grip tubing from the side to make bends in tight spaces.

Powerful enough to bend conduit and pipe to the angle you need with one stroke of the pump, these are for use on Schedule 40 pipe.

Choose these benders for short-radius conduit bending.

Bend wire and rod up to 3/8" diameter and flat stock up to 1/2"×3/16".