Mount the male thread on the bottom of the light through a hole and then secure using the included nut. Lights have LED bulbs for years of maintenance-free operation. They meet IP65 for protection from washdowns.

These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack. They meet NEMA 4X for protection from corrosion and washdowns.

Use the extension pipe and mounting flange to make the light taller (both sold separately).

Use the vertical-mount bracket (sold separately) to mount the light to a vertical surface such as a wall.

For technical drawings and 3-D models, click on a part number.

Mount these lights horizontally or vertically in places where a tower will not fit. The LED bulbs provide years of maintenance-free operation. Lights meet IP54 for use in environments with splashing water.

For technical drawings and 3-D models, click on a part number.

Choose from seven colors, including nontraditional colors such as magenta and turquoise, for a custom four-light stack light. Assign colors by pushing your machine's wire leads into the spring-clamp terminals in the light's base. As your operations change, update the colors by opening the base and rearranging the wire connections. Lights have LED bulbs for years of maintenance-free operation. They have clear lenses, which are helpful in bright environments where it can be difficult to see whether a light is on or off. They meet IP66 for protection from high-pressure washdowns.

The quick-connect four-pole M12 plug on these lights makes them easy to hook up and configure. Mount the male thread on the bottom of the light through a hole and then secure using the included nut and sealing gasket. Lights have LED bulbs for years of maintenance-free operation. They meet IP65 for protection from washdowns.

Give a signal with the push of a button. These lights have a control box with a button for activating each of the three light modules. The LED bulbs provide years of maintenance-free operation.The light modules meet IP54 and the control box meets IP20. They cannot be sold to the regions listed due to local energy efficiency requirements.

Mount the light by bolting the included bracket to a surface (fasteners not included) or clamping it over a surface such as an office partition or workstation. You can adjust the height of the light by using either the included 3 1/2” or 11 3/8” mounting poles.

Mount the control box using the included tape with adhesive on both sides. It connects to the light via a 4-ft. connecting cable.

For technical drawings and 3-D models, click on a part number.

These lights have LED bulbs for years of maintenance-free operation and can be wired as either continuous or flashing. The beep or buzzer alerts workers when they're outside a direct line of sight. Lights meet IP65 for protection from washdowns.

Replacement mounting pipes can be cut to length. Use them to lengthen the existing pipe or to replace it entirely.

For technical drawings and 3-D models, click on a part number.

Also known as turret lights, these fixtures have uplight or downlight reflectors to direct light. They work well in indoor workspaces such as offices and storage rooms where directed or ambient lighting is important. Lights can be hardwired to operate on any of the voltages listed.

Downlight reflectors focus light on a workspace by capturing all light and directing it downward. Uplight reflectors have openings that allow some light to escape, reducing glare and creating more ambient lighting than downlight reflectors.

Lights with built-in LEDs last longer, are more efficient, and generate less heat than fluorescent lights. They emit a neutral white light often found in workspaces.

Lights without bulbs work with tubular fluorescent bulbs (sold separately).

Add suspension hardware (sold separately) to hang lights from the ceiling. Includes two wire rope slings with hooks and two wire rope clamps. No tools required—adjust the length and tighten clamps to secure.