This cable has twisted pairs of wires that cancel signal interference from multiple transmission lines. Use it for complex and high-speed data and signal transmission.

Send data between computers, servers, and switches in an office or workstation.

Also known as plenum cable, this cable has low-smoke insulation and can be used without conduit in ductwork and above a drop ceiling. Use it to send data between computers, servers, and switches.

Also known as plenum cable, this cable has low-smoke insulation and can be used without conduit in ductwork and above a drop ceiling. It has an oil-resistant insulation to protect wires as the cable moves from duct to equipment or machinery.

The shielding blocks signal interference from nearby equipment and devices.

Unlike the RJ45 ends on traditional Ethernet cords, the threaded M8 ends on these cords keep contaminants out and resist coming loose from vibration.

To send high-speed data in tough, rugged environments, these cords have an M12 connector on one end that threads onto switches, sensors, and other devices prone to vibration. The other end has a traditional RJ45 plug that connects to Ethernet equipment, such as computers, IO modules, and programmable logic controllers (PLCs).

Use these unshielded cords where signal interference is not a concern.

The plugs on these cords pivot up to 90° in each direction to fit Ethernet jacks at awkward angles or in tight spots, such as behind equipment or in enclosures.

Often used in assembly line networks and Fieldbus connections, these cords have B-coded M12 connections.

Commonly used for movie, stage, and interior building lighting, these cords connect to equipment with five-pin XLR connections.

Use these connectors and cords to make Ethernet connections in wet location environments.