Mount these pulleys to a flat surface to assist with horizontal pulling or to guide a rope.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Mount these pulleys to a flat surface to assist with horizontal pulling or to guide a rope.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Mount these pulleys to a flat surface.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Mount these pulleys directly onto a shaft to transmit rotary motion and torque.

These pulleys are cast iron.

Increase efficiency, vary speed, and extend the life of your drive by changing the pitch on these pulleys.

Mount these pulleys with a taper-lock bushing for a tight, wobble-free hold on your shaft.

Use these pulleys with compatible quick-disconnect bushings.

Pulleys are anodized aluminum, which is more corrosion resistant than steel.

Anodized aluminum has good corrosion resistance.

Add these free-spinning pulleys to your timing belt setup to minimize vibration and keep belts from wearing out.

Carry heavy loads without slippage—pulleys mount with a bushing for a more secure grip on the shaft than set screws.

Move heavy loads without slippage—pulleys mount with a bushing for a more secure grip on the shaft than set screws.

Made of aluminum, these pulleys have good corrosion resistance.

These HTD (high torque drive) pulleys have a curved tooth shape that provides higher strength than trapezoidal teeth.

Curved teeth with a high pitch provide superior load distribution and reduce wear. They mount with a bushing for a more secure grip on the shaft than set screws.

Teeth are curved and set in an offset pattern for high strength with 25% less operating noise than pulleys and belts with trapezoidal teeth.

Also known as paper-plant pulleys, these are made of a paper-fiber composite that minimizes belt slippage and wear.

Thread the stud directly into a component or secure with a nut for through-hole mounting.

Support and guide loads on angle rails in food, pharmaceutical, and other sanitary environments. Also known as yoke-style cam followers, these track rollers offer more mounting flexibility than threaded alternatives and are typically mounted on shafts and clevis rod ends.

Make your own wheels by cutting these wheel blanks to size with a band saw. They're easy to machine so you can create V-groove and flanged wheels, as well as conveyor rollers and pulleys.

The wheels of these casters have a 90° V-groove and a flat tread to move your equipment on angle-iron track as well as the floor.

The wheels of these casters have a 90° V-groove and a flat tread to move your equipment on angle-iron track as well as the floor. Polyurethane wheels combine the abrasion resistance of plastic with the shock- and sound-absorbing qualities of rubber. Their 304 stainless steel frame is corrosion resistant.