We will reply to your message within an hour.
More
These U-cup seals create less friction than O-ring-loaded U-cups, so they wear more slowly. Also known as lip seals, U-cups have a sealing lip on both the inside and outside edges, so they can be used for rod and piston sealing.
Rated for pressure up to 10,000 psi, these leather U-cups handle over 80 times more pressure than our Buna-N U-cups.
Also known as loaded-lip seals and PolyPaks, an O-ring secures these U-cups to the rod or piston for better sealing performance at lower pressures than unsupported U-cup seals.
Also known as Type B seals, these U-cups are wider than our other O-ring-loaded U-cup seals for better stability and fit in wider grooves.
These Buna-N seals are reinforced with cotton thread for strength.
Use these Buna-N rubber gaskets with grip-lock and double grip-lock hose couplings.
A mounting plate provides a more secure hold at the mounting surface.
Mount these general purpose U-bolts into an existing bracket, or combine with a mounting plate for a secure hold at the mounting surface.
Suspend and route flat-bottomed objects such as strut channel and small duct.
Also known as muffler clamps, these U-bolts have a rounded mounting plate that fully surrounds pipe, conduit, and tubing for a secure fit.
A durable rubber cushion and mounting plate prevent corrosion and wear caused by metal-to-metal contact. The mounting plate is removable, so the U-bolts can be installed onto an existing line without needing to disassemble it.
These fiberglass-reinforced polyurethane U-bolts have no metal parts, so they won't conduct electricity or cause metal-to-metal corrosion.
Reduce vibration and prevent metal-to-metal corrosion on flat-bottomed objects such as strut channel and small duct.
Reduce vibration and noise in your lines—a plastic cushion tightly grips pipe, tubing, and conduit to prevent movement. Nylon-insert locknuts grip the thread to resist loosening.
Replace all the seals on the rod end of a hydraulic cylinder.
Replace all the seals on the piston of a hydraulic cylinder.
These kits include the rod gland with all of the seals installed.
For a more secure hold than standard hoist rings, weld these hoist rings to your load.
Designed for angular lifting, hoist rings resist stresses that would bend or break an eyebolt. They have a lifting ring that pivots 180° front to back to compensate for roll and sway when lifting heavy or unbalanced loads.
Keep on hand all the parts needed to assemble custom hoist rings.
An indicator dot changes from red to black when these hoist rings are properly tightened, eliminating the need for a torque wrench.