These rods offer excellent electrical-insulating properties. They’re often used for circuit-breaker housings, manifolds, and semiconductor components.

Parts made with these filaments remain strong and rigid in temperatures that would soften most plastics. They are a lightweight alternative to machined metal parts. Use with a fused filament fabrication (FFF) 3D printer to make parts that will be used near ovens, engines, and other hot machinery. These filaments require an all-metal extruder to reach the recommended printing temperatures. Print parts onto a heated bed to keep them from warping as they cool.

PEI filaments have electrical-insulating properties, which make them good for printing circuit-breaker housings and semiconductor components.

PEKK filaments can be printed at a lower temperature than PEEK and produce parts that withstand more heat. Parts printed with PEKK must be annealed to reach their full strength and heat resistance. Tensile strength is the best measure of a filament's overall strength. Similar to the stress applied on a rope during a game of tug-of-war, it's the amount of pulling force a material can handle before breaking. A higher rating means a stronger filament. A tensile strength of 5,000 psi and above is considered good; 12,000 psi and above is excellent.

Maximum exposure temperature is the point at which a printed part will begin to deform. Above this temperature, your printed parts will start to lose structural integrity.

Annealing is the process of heating prints to a specific annealing temperature and then slowly allowing them to cool. This makes the finished print harder, stronger, and more heat tolerant. Maximum temperature after annealing replaces the maximum exposure temperature once this process has been completed.