For a strong, continuous grip, these lifters have levers to lock them in place. Flip the levers back to release the suction. Use on smooth, nonporous surfaces, such as mirrors and metal sheets.

Style C has swiveling cups for mounting flexibility.

Replacement cup kit includes a cup, a lever, and a spring.

Holder mounts to a wall for quick lifter access.

Note: Capacities are for vertical lifting.

Warning: Never use to lift items over people.

These tools create a vacuum and have fingertip control to pick up and release small, delicate parts. Use on smooth, nonporous surfaces.

Push Button—Press the button to create the vacuum; press it again to release. The body has a storage compartment to hold the extra tips. This lifter can withstand high-temperature applications.

Squeeze Bulb—Squeeze and release the finger-size bulb to create the vacuum; squeeze the bulb again to release. A plastic box holds the lifter and extra tips.

This lifter uses a quiet continuous-vacuum system and fingertip control to pick up and release small, delicate parts. Press the button on the probe to release suction. Use on smooth, nonporous surfaces, such as mirrors and metal sheets.

Also known as vacuum chucks, these plates secure thin and flexible parts that can’t be held with vises or clamps for milling, drilling, routing, and finishing operations. Connect the system to your shop’s compressed air supply and it's ready to use. For applications requiring only part of the plate surface, use the gasket cord to seal off the area.

Risers, also known as vacuum pods, raise the workpiece off the vacuum table to give the cutting tool better access. Suction transfers from the table through the top of the riser, so to get a firm hold the workpiece must make contact with the full top length and width of the riser.

Retracting stop pins let you repeatably locate parts on your vacuum table. After positioning your workpiece against these pins, turn on the vacuum and the stop pins retract, dropping out of the way so the cutting tool has full access to the workpiece.

Side stops fit into the grooves of the vacuum plate to help you repeatably position material. They can be removed from the plate after the vacuum is turned on to give the cutting tool more access to the workpiece.

For applications requiring only part of the vacuum plate surface, use gasketing to seal off the in-use area. Cut to length. Choose the cross-section shape recommended by your vacuum workholding system manufacturer to ensure the best performance.