Free of metal particles, these lubricants won’t react with stainless steel. Also known as thread lubricants, antiseize lubricants prevent threaded fasteners and close-fitting parts from locking together due to corrosion, contamination, or heat.

Corrosion-resistant additives allow these lubricants to prevent parts from locking together in caustic environments, such as steel mills and power plants.

Often used with engine bolts and heavily-loaded, slow-moving gears, these lubricants are formulated with moly (molybdenum disulfide) to prevent parts from locking together under high loads and pressure.

Copper allows these lubricants to conduct electricity, while graphite gives them good chemical and corrosion resistance. Use them to prevent threaded fasteners and close-fitting parts from locking together in connections where you need to conduct electricity.

Use these lubricants to prevent threaded fasteners and close-fitting parts in food-processing and preparation areas from locking together. They're NSF registered H1 for incidental food contact.

A firm consistency and resistance to evaporation make this grease ideal for vacuum applications, such as flow meters, vacuum and pressure systems, and laboratory equipment.

Fluorocarbon and fluorinated polymer thickeners add chemical resistance to this grease. It remains intact when exposed to water and most solvents and chemicals.

This thin grease goes on as a film to form a seal in glass and metal stop cocks.

Highly pure, this grease is chemically inert, so it won’t contaminate sensitive environments or react with other substances. Due to its low vapor pressure, it resists evaporation, even at high temperatures.

Coat tight-fitting metal parts with these lubricants before sliding them together to make assembly easier. Once assembled, they provide initial lubrication in equipment before oil has a chance to flow.

This oil is chemically inert and long lasting with an indefinite shelf life.

Apply directly to seals and O-rings to extend service life by preventing drying and cracking.