These valves are rated for at least three times the pressure of standard threaded valves. Use with water, oil, air, inert gas, and steam.

Use these valves with water, air, and inert gas.

Also known as wafer ball valves, these combine the slim body of a butterfly valve with the high flow rates of a flanged ball valve. They bolt to ANSI flanges. Use with water, oil, air, inert gas, and steam.

For fast installation and removal from pipelines, these valves have union fittings that disassemble into multiple pieces. Insert unthreaded pipe into the socket ends and bond with primer and cement to create a permanent, leak-tight connection. These valves meet NSF/ANSI 61 for use in drinking water lines.

Disassemble the union fittings on these valves for fast installation and removal from your pipeline. All meet NSF/ANSI 61 for use with drinking water.

The three-piece bolted body comes apart for access to internal components without unthreading pipe connections and removing the valve from your line. Seal is fluoroelastomer and body is polypropylene for excellent resistance to aggressive and corrosive solutions in chemical-processing applications.

Insert unthreaded pipe into the socket ends and bond with primer and cement to create a permanent, leak-tight connection. These valves have a fluoroelastomer seal and a plastic body that can withstand aggressive and corrosive solutions in chemical-processing applications.

These valves have a sharp gate that slices through thick slurries, wastewater, dry bulk solids, and other materials that would clog other gradual on/off valves.

Their ball-valve design allows these valves to handle three times the flow of butterfly valves.

Use these valves to safely transfer fuel and oil.

Their ball valve design allows these valves to handle three times the flow of butterfly valves.

Use these valves to safely transfer fuel and oil.

These valves are for use with water, oil, air, and inert gas. They bolt to flanges to adjust and regulate flow in flanged pipelines.

An aluminum body provides strength and durability at half the weight of other metal flanged flow-adjustment valves. These valves are for use with water, oil, air, and inert gas. They bolt to flanges to adjust and regulate flow in flanged pipelines.

Often used in low-pressure water pipelines, these valves have a plastic body for the lightest weight of our flanged flow-adjustment valves. Use them with water. They bolt to flanges to adjust and regulate flow in flanged pipelines.

In addition to fluoroelastomer seats that resist a wide range of chemicals, these valves have no metal parts to corrode, so they’re often used for chemical-processing applications in corrosive conditions. All bolt to flanges to adjust and regulate flow in flanged pipelines.

Rated for steam pressures up to 100 psi @ 400° F, these valves have PTFE seats for excellent temperature resistance. They bolt to flanges to adjust and regulate flow in flanged pipelines.

Bolt these valves to flanges. Use them with water, oil, air, and inert gas. All operate on compressed air to automatically divert flow between ports more quickly than motor-driven valves. You must control the air to the actuator using either an electric pilot valve or a manual on/off valve.

To achieve the maximum possible flow, internal components are designed to reduce flow resistance.

Bolt to ANSI flanges.

Less than half the end-to-end length of standard flange-mount check valves, these can be installed in pipelines with limited clearance.

Weld to unthreaded metal pipe.

These valves open to allow flow in one direction and close when flow stops or reverses.

For more durability than plastic, these valves have a metal body.

Install these valves between ANSI flanges.

Couplings are metal, which has better durability than plastic cam-and-groove hose couplings. Also known as dry disconnects and double shut-off couplings, they have a shut-off valve in the plug and the socket for minimal fluid loss when disconnecting your hose line.