We will reply to your message within an hour.
Protect against excess vacuum and pressure in cylinders, gear boxes, enclosures, manifolds, and tanks.
These breather vents withstand corrosion in damp environments.
These breather vents are rated NEMA 6 to withstand periodic submersion in water.
Shield outdoor pipe and tank openings from the environment. Also known as vent caps, these breather vents have screens to allow air flow while blocking debris.
Secure access to vented openings in pipe and tanks—the cap can be locked to prevent tampering.
Add a filling port to your hydraulic tank while protecting against excess pressure and vacuum.
Minimize moisture buildup in enclosures. Also known as drain plugs, these breather vents have a small outlet that allows condensation to drain.
Keep moisture, dirt, and debris from entering your oil reservoirs.
Use the bypass tube on these plugs to add air, water, and other fluid to your pipeline or to relieve pressure while testing.
Use the bypass tube to add air, water, and fluid or relieve back pressure.
Use the bypass tube on these plugs to add air, water, and other fluid to your pipeline or to relieve back pressure while testing.
Vents in the top allow air circulation and permit heat and fumes to escape. All of these plugs have wings that expand against the sides of the hole to lock them in place.
Vents in the top allow air circulation and permit heat and fumes to escape. These plugs have tapered prongs that snap into the hole to securely hold them in place.
Use these vents to maintain consistent pressure as temperatures fluctuate by allowing air to flow through sealed enclosures.
Safe for use around flammable and combustible gases, vapors, fibers, and dust, these vents allow air to flow through enclosures to maintain consistent pressure and reduce moisture buildup as temperatures change. They also stand up to washdowns.
These vents have louvers with foam filters to keep out dust and falling liquids.
Rated NEMA 4X, these vents provide protection from washdowns, corrosion, and power jets of water.
These vents maintain air pressure inside enclosures that may be exposed to indoor and outdoor temperature changes while keeping dust and water out.
No threaded hole or tools needed—snap these vents into enclosures with a maximum 1/8” panel thickness to let airflow in and keep water out even when submerged.
Safe for use around hazardous gasses and dust, these vents maintain steady pressure and prevent moisture buildup from temperature changes inside enclosures.
Secure cable installed through enclosures in wet environments while venting air to protect electronics from condensation.
Vent air from your enclosure to equalize pressure and stop condensation from forming inside while securing cords in wet environments. These polyamide grips are lightweight and resist rusting.
To protect equipment from damage, the slit in the threads of these fittings acts like a breather vent, releasing any excess pressure and grease.
Often used with trailers, compressors, and other fuel tanks, these caps meet Department of Transportation requirements.
The flat side of these pins relieves trapped air, making them easier to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.
A spiral groove cut into these pins relieves trapped air but stays in 360° contact with the hole for a secure fit that's easy to insert in and remove from blind holes. To remove, thread a screw or tool into the tapped hole, then pull the pin out.