Clear All
Mount Type Mount Type | Show |
|---|
|
Mount Type Mount Type | Hide |
|---|
|
|
System of Measurement System of Measurement |
|---|
|
For Slot Width For Slot Width |
|---|
|
Thread Size Thread Size |
|---|
Vise Type Vise Type |
|---|
 | Machine |
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Tilt Range of Motion Tilt Range of Motion |
|---|
|
T-Slot Nut Base Width T-Slot Nut Base Width |
|---|
|
Slot-Mount Workstops for Machine Vises
For 2"-6" Jaw Wd.
For 4"-6" Jaw Wd.
For 2"-6" Jaw Wd.
For 4"-6" Jaw Wd.
Mount these workstops into slotted vise jaws—they hold workpieces in place and prevent horizontal movement during machining. Tighten them in place with screws for precise positioning. Unlike other workstops, they don’t grip the outside of jaws, so they’re less likely to interfere with your vise.
13/16"-long workstops mount anywhere along the length of a vise jaw.
1-11/16"-long workstops hold work that extends beyond the width of a vise jaw. They must be positioned on the ends of the jaw.
Machine Table Workstops
The T-nut base secures the workstop into the slots of a machine table for positioning parts that extend beyond the jaws of your vise. Workstops tilt 180° and have an adjustable stop pin that slides in and out for precise positioning.
T-Slot Nut Base | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| For Slot Wd. | Lg. | Wd. | Ht. | Thread Size | Ht. | Wd. | Features | Each | |
Aluminum | |||||||||
| 5/8" | 5 29/32" | 2 5/16" | 1 1/4" | 1/2"-13 | 11/32" | 1" | Adjustable Stop Pin | 00000000 | 000000 |