Also known as wall packs, these lights mount to exterior walls and ceilings.

Mount this light on a pole to illuminate pedestrian areas such as streets and walkways.

Powered by the sun, these security lights function in areas that don’t have access to electricity. They’re often used to shine light on parking lots, landscaping, signs, entryways, and other outdoor spaces.

These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

These lights mount to the wall so they're often used in enclosed spaces such as stairwells, hallways, and storage rooms.

Customize these lights to label doors or areas of a building.

Illuminate steps to reduce the risk of tripping or falling, especially at night or in poorly lit areas.

These lights produce a wide beam of uniform light to fill large, open areas with ceilings up to 18-ft. high.

Built for hot, hazardous areas such as steel mills and refineries, these lights work in temperatures up to 212° F. Rated NEC Classes I and II, they’re safe to use where there are ignitable concentrations of flammable or combustible gases, vapors, liquids, and dust.

No need for wiring—these lights plug-in with a two-prong plug.

These lights are UL rated for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

These lights are sealed to protect against humidity, moisture, and dripping and splashing liquids.

A mounting clip at the base lets you attach these lights to nearby surfaces.

Hang these lights above your workspace—they shine through long tubes to distribute even light with minimal glare and shadows. Carry them where you need them and suspend them from pipes, beams, and other overhead surfaces.

Hang a string of lights overhead to brighten wet jobsites. IP rated, these lights are sealed to keep out dust and moisture from washdowns, splashes, and sprays, even outdoors.

Hang these lights where you need them on the job site.

A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

Aim light where it's needed most in areas that don't have an electrical outlet.

From pipes to pallet racks to control panels—these lights clamp onto almost anything and swivel to direct light just where you need it.

Bring light to areas that don't have electrical power service.

Aim light where you need it—even in explosion-prone spaces—by raising, lowering, and tilting these lights on their tripod. Rated NEC Classes I, II, III, and Zone 0, they’re safe to use near ignitable concentrations of flammable or combustible gas, dust, or fibers.

Bring light to explosion-prone work areas. Rated NEC Class I, these lights are safe to use in areas with ignitable concentrations of flammable or combustible gases, vapors, and liquids.

Bring light to remote, wet areas. These floodlights are IP rated to handle humidity and dripping, splashing, and falling liquids. Adjust their tripod up and down to direct light as far as you need.

Brighten remote areas using the same battery as your other cordless Milwaukee tools.

These lights can switch between being continuous or flashing.

Mount these lights horizontally or vertically in places where a tower will not fit.

Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.