We will reply to your message within an hour.
These lights produce a wide beam of uniform light to fill large, open areas with ceilings up to 18-ft. high.
Also known as jelly jar lights. These fixtures have a guard that protects the lens from breaking.
Mount lights in recessed spaces so the lens is flush with the wall.
These lights mount to the wall so they're often used in enclosed spaces such as stairwells, hallways, and storage rooms.
Don’t waste energy lighting unoccupied spaces--these lights turn on when they detect movement. Set them to turn off after 30 or 180 seconds.
These LED lights have an air-tight seal to protect against contaminants.
Mount this light on a pole to illuminate pedestrian areas such as streets and walkways.
Mount these lights near entry doors, loading areas, and driveways to cast an even glow of light.
Heads adjust to any angle so you can direct light where needed.
Illuminate outdoor areas and objects such as parking lots, flag poles, and billboards.
These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.
Also known as wall packs, these lights mount to exterior walls and ceilings.
Powered by the sun, these security lights function in areas that don’t have access to electricity. They’re often used to shine light on parking lots, landscaping, signs, entryways, and other outdoor spaces.
These lights automatically turn on when movement is detected and off when an area is unoccupied.
Mount add-on heads in remote areas to extend emergency lighting.
No need for wiring—these lights plug-in with a two-prong plug.
These lights are UL rated for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.
Rated for use in damp locations, these lights withstand humidity and moisture.
These lights are sealed to protect against humidity, moisture, and dripping and splashing liquids.
Rated NEMA 4X, these lights are protected from corrosion and washdowns.
These lights have lenses that snap in and out, so you can easily swap colors or change their position in the stack.
Mount these lights horizontally or vertically in places where a tower will not fit.
Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.
These lights have LED bulbs for years of maintenance-free operation and can be wired as either continuous or flashing.
These lights can switch between being continuous or flashing.
Direct your signal with these lights; they flash in one direction.
Direct traffic with these colored lights.