Made of 85% pure nickel, these electrodes join cast iron to itself, and to mild steel and stainless steel.

Increase the wear resistance of your base metal, or restore a worn-down surface with these electrodes.

Weld nickel with these electrodes.

Use these ERCuAl-A2 rods to join different metals, such as cast iron, steel, stainless steel, copper, and bronze.

Often used to repair pipe, these rods join nickel alloys to themselves and to stainless steel and steel.

A two-part alternative to standard electrodes, these electrodes reduce waste since you can reuse the shank.

Use these brazing alloys with a variety of metals.

Create stronger bonds than standard brazing alloys.

Use these alloys on metal subject to corrosion.

To fill in large gaps, these BAg-2 alloys melt into a thicker liquid than standard brazing alloys.

Fill in tight gaps without needing to add flux before you braze—these alloys have flux built in. When melted, these alloys form a thin liquid that easily flows into smaller gaps than standard brazing alloys.

Use this flux with silver and copper-based brazing alloys to clean and prepare surfaces.

This solder meets NSF/ANSI Standard 61 for drinking water.

This bismuth-tin solder has similar performance properties to lead solder, but is also safe for use in food-processing equipment and copper water pipes.

The silver in this solder helps it resist vibration to form strong joints in HVAC systems. Since it doesn’t have a flux core, you can choose the flux that works best for your application.

The flux residue easily washes away with water.

This solder keeps its strength in applications where vibration and frequent and extreme temperature changes occur, such as in water lines and refrigeration equipment.

Rosin flux is quick acting with strong cleaning action, but leaves residue that requires flux remover.

Acid flux has strong cleaning action, but leaves corrosive residue that washes away with water.

Acid flux has strong cleaning action, but leaves corrosive residue that washes away with water.

Electrically conductive and with five flux cores, this solder speeds up the process of soldering electronics, so you use less solder and transmit less heat to the joint. Easily wash away the flux residue with just water.

The flux leaves minimal residue so there's no need for cleanup.

Wash away flux residue from this solder with water.