Rated for use in damp locations, these lights withstand humidity and moisture.

Mount add-on heads in remote areas to extend emergency lighting.

Direct light where it’s needed with these pivoting-head flashlights. When plugged in, they’ll automatically light up if the power goes out.

The smooth stainless steel surface allows for easy cleaning.

Tilt the head on these flashlights to aim light exactly where it's needed. They have a flat bottom, so you can work hands-free without them rolling away.

Shine light into hard-to-reach spaces with these flexible-arm flashlights.

Rated for use in environments where hazardous material is present.

Attach to your key ring or hat so you’ll always have a flashlight on hand. They're rated for use in environments where hazardous material is present.

Because these flashlights are buoyant, they're easy to recover when dropped in the water.

Rated IP07, these headlamps withstand temporary submersion in a maximum of one meter of water for up to 30 minutes.

Hang these lights where you need them on the job site.

A series of bulb heads are attached to a power cord to provide overhead lighting for job sites.

With a NEMA 4X rating, these lights resist degradation when exposed to corrosive liquids, withstand liquids sprayed during washdowns, and are dust tight.

Compact and easy to carry, these IP65-rated lights stand up to dust and low-pressure jets of water. The head adjusts up and down as well as side to side to direct light where it's needed.

The handle on this floodlight also acts as a stand—pivot it 360° to aim light where it's needed. This floodlight is small and easy to carry to job sites that don't have electrical power.

Heads adjust to any angle so you can direct light where needed.

These lights automatically turn on when movement is detected and off when an area is unoccupied.

These lights are UL listed for use in hazardous locations where flammable/combustible gases, vapors, and liquids may be present.

The pad below the base absorbs shock and vibration.

These lights cycle through three different flashing patterns.

These lights cycle through three different flashing patterns.

Quickly position these portable flashing lights using the magnetic base to draw attention to hazards in areas such as docks and railroad crossings. They are battery operated, so they do not need to be wired or plugged in.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

Easier to spot than other strobe lights, these lights emit bursts of five flashes per cycle.

As small as a hockey puck and compatible with standard 12-volt vehicle plugs, these strobe lights are inconspicuous when not in use and quick to connect.

A series of four flashes per cycle makes these lights more visible than other strobe lights.

Screw into a standard medium-base light socket.

These lights can switch between being continuous or flashing.

Mount the M22 male thread on the bottom of the light through a hole and then secure using the included nut.

Use these lights in tight spaces in place of a tower. They emit three colors from a single lens.

Design a stack light with your choice of light pattern and color. Start with a base, then add up to five modules total—twist and lock them together.

The quick-connect four-pole M12 plug on these lights makes them easy to hook up and configure.

Give a signal with the push of a button. These lights have a control box for activating each of the three light modules.