Fit these wheels over your tool's arbor. The flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces.

With alternating cloth and nylon mesh abrasive flaps, these wheels are more flexible and produce finer finishes than all-cloth flap wheels.

Holes in the disc let you see the surface you’re sanding.

The premium abrasive stays sharp longer.

Holes in the disc let you see the surface you’re sanding.

The premium abrasive stays sharp longer.

Fit these discs over your tool’s arbor to sand stainless steel and hard metals.

Used for stripping, these discs eliminate discoloration from heat buildup.

Fit these discs over your tool's arbor to sand aluminum, soft metals, and nonmetals.

With more flaps than standard discs, these last 30-40% longer.

The flaps have an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

The flaps wrap around the outer edge of these discs to sand welds at right angles.

Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

With more flaps than standard discs, these last 30-40% longer.

The flaps alternate between an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

The backing plate on these discs can be sheared away as the abrasive flaps wear down, allowing you to use more of the disc rather than replacing with a new one.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

The flaps have an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Made of phosphorus bronze that is Factory Mutual approved, these brushes inhibit sparking and are nonmagnetic and corrosion resistant.

A mounting nut on each side of the arbor lets you use both sides of the brush.

Bristles are partially twisted in alternating directions, which prevents them from separating.

Use on delicate surfaces.