A two-lip design means that these wipers also function as a rod seal.

These wipers seal against the cylinder housing to prevent contaminants from entering between the outside edge and the housing.

Secure a wiper on the end of a ball nut to sweep chips and other contaminants out of the way as it moves across the ball screw.

Brushes have dense bristles that can dust, stop, and separate items on a conveyor as well as keep heat, sprayed liquids, and chips contained.

These brushes have a stainless steel backing for corrosive environments.

Brushes have nonstick PTFE bristles for temperatures up to 500° F.

The bristles on these brushes contain a compound that metal detectors and x-ray equipment can detect.

Bristles are polypropylene so they remain stiff even when wet.

Brushes are made of FDA listed materials so they can be used for food and beverage conveying.

With a tight spiral bristle pattern, these brushes are effective for cleaning conveyor belts and chain.

Bristles made from FDA listed materials and stainless steel hardware make these brushes appropriate for food and beverage conveying. Position them on an angle to fit 11" to 29" wide conveyors.

Use these belt scrapers to remove debris from conveyor belts. If a chip of this blade breaks off near a process line, it can be located by metal detectors to reduce contamination risks in food processing applications.

A flexible, nonscratching, silicone blade lets you wipe irregular and rounded surfaces.

Assign colors to avoid cross contamination. A channel-free blade prevents debris from getting stuck inside the blade.

Clear away debris and water with one tool.

FDA compliant for direct contact with food, these squeegees are good for use in food-service and hospital environments. They have a nonmarking blade and a sanitary handle.

A scraper removes tough debris.

PVC blades resist oil, grease, and solvents.

Apply concrete and asphalt sealants as well as floor coatings.

Choose the right blade for the job to spread water- and solvent-based floor coatings evenly.

Adjust the height of the metal blade to get a consistent application thickness for water- and solvent-based floor coatings. Their metal blades can handle tough coatings, such as concrete and harsh solvents. Applicators are also known as gauge rakes.

Use these brushes to apply paste for wall coverings.