Tap and splice multiple wires together at the same time.

Splice large size wires without special tools—insert your wires and tighten the hex nut to make a connection.

Connect a tap wire to a main wire without stripping—these wire taps penetrate insulation.

Tap a main wire or add a finished terminal to the end of a wire.

Pierce the insulation of wire without stripping it to make quick connections that are also sealed to keep out water.

The straight tongue improves conductivity by increasing the surface contact between the lug and your equipment.

Connect these lugs to cable with a crimping tool or by soldering.

Serrations on both sides lock these lugs in place.

When heat is applied, the flux and solder mixture creates a metallic bond that is nearly twice as strong as crimping or compression connections.

Connect these clamps to cable with a crimping tool or by soldering.

Insert your stripped cable into the compression nut and tighten; no crimping or heat is required.

Save time when wiring connections in a junction box; these blocks come already installed in an enclosure.

The spring-clamp terminals on these blocks make wire installation faster than other types of terminals. These wire connections also stand up to vibration and temperature changes.

Use with DIN 2 rail. Add as many circuits as you need with these terminal blocks and accessories.

Use with DIN 3 rail. Add as many circuits as you need with these terminal blocks and accessories.

Best for equipment requiring regular servicing, these blocks disconnect without having to remove any wiring thanks to their plug-and-socket design. Their recessed screws prevent shorts by reducing the risk you’ll connect two circuits with a screwdriver or other tool.

Meet international standards IEC 309-1 and 309-2.

Made with industry standard barrel-style ends, these connectors carry DC power between electronic devices and power supplies.

Connect one end to a fixture and the other to a ballast. These connectors allow you to safely disconnect a failed ballast without exposing you to live wires.

Configure a connector for your application—combine inserts for power and signal with a base and a hood.

Designed specifically for use with welding circuits.

Connect bare-copper ground wire to grounding rods.

Create a common grounding path for not only internal components and circuits, but also your enclosure’s body.

Join two grounding wires to extend the length of your grounding connection or connect to an existing ground wire.

Test equipment that draws more than 10 amps of current. These clips are spring loaded to hold tight for hands-free testing.

Also known as a geophone clip, this clip has rounded jaws that clamp onto battery terminal lugs and other curved surfaces for hands-free testing.

Compared to metal loop clamps, plastic loop clamps reduce wear on soft materials, such as tubing and cable. Clamps are nonconductive and noncorrosive.

Organize multiple lines of pipe, tubing, and conduit with one clamp. Wider than standard loop clamps, multiline loop clamps surround two lines of material to create a secure grip while holding the lines close to the mounting surface.

Organize multiple lines of pipe, tubing, and conduit with one clamp. Wider than standard loop clamps, multiline loop clamps surround two lines of material to create a secure grip while holding the lines close to the mounting surface. A cushion covering the clamp reduces vibration and wear from clamp edges.

These cables are for occasional use on cars and other small transport vehicles.

Convert one battery terminal style to another.