Use the twin hooks to suspend items from two points and use the loop to secure the suspended material. For use with cable trays or signs.

Also known as spade bolts, you can use these versatile hangers in a threaded hole (as you would a screw), or secure them with a nut (as you would a bolt). Zinc plating provides corrosion resistance in wet environments. Material meets ASTM A307 or F2282 specifications for quality.

For technical drawings and 3-D models, click on a part number.

These hangers are a popular choice for overhead applications. To install, insert the bolt through your fixture and thread the toggle onto it. Next, fold the toggle wings flush against the bolt and push them through a drilled hole until they pop open on the other side. Pull back on the bolt and tighten. They’re zinc plated for corrosion resistance in wet environments. Dimensions meet ASME B18.6.3 specifications.

For technical drawings and 3-D models, click on a part number.

These hangers are a popular choice for overhead applications. The spring holds the washer and toggle against opposite sides of the wall, so everything's in position before you begin tightening. To install, insert the bolt through your fixture and thread the toggle onto it. Next, fold the toggle wings flush against the bolt and push them through a drilled hole until they pop open on the other side. Once tightened, the spring adds vibration resistance. Zinc yellow-chromate plating provides corrosion resistance in wet environments. Dimensions meet ASME B18.6.3 specifications.

For technical drawings and 3-D models, click on a part number.

Drive these hangers into wood with an adjustable wrench, pliers, or a special driver bit (sold separately). They’re also known as eye lags.

Zinc- and zinc yellow-chromate plated steel hangers are corrosion resistant in wet environments. The zinc yellow-chromate plated steel hangers meet quality standards outlined in ASTM B633 and dimensional standards outlined in ASME B18.2.1.

316 stainless steel hangers have excellent resistance to chemicals and salt water. They’re best for corrosive and marine environments.

For technical drawings and 3-D models, click on a part number.

Drill a hole into concrete or other hard surfaces, and hammer in these hangers. Once the hanger is inserted, pulling on the head with the claw of a hammer will cause the base to expand, wedging the hanger in place. They’re zinc plated for corrosion resistance in wet environments.

For technical drawings and 3-D models, click on a part number.

Drill holes with the point on these hangers. Install with a special driver bit (sold separately).

Zinc-yellow-chromate-plated hangers are corrosion resistant in wet environments. Zinc-yellow-chromate-plated hangers with a 3/8" head width can drill through steel sheet metal as thick as 16 ga. Some hangers with a 7/16" head width can drill through steel as thick as 12 ga.; others can drill through sheet metal and wood.

Blue ultra-corrosion-resistant-coated hangers are 40 times as corrosion resistant as zinc-yellow-chromate-plated hangers, withstanding up to 1,000 hours of salt spray. They can drill into structural steel up to 1/4", such as steel beams. They’re not for use with sheet metal thinner than 12 ga.

For technical drawings and 3-D models, click on a part number.

These hangers have internal threads for use with threaded rods, bolts, and anchors. They’re zinc plated for corrosion resistance in wet environments.

For technical drawings and 3-D models, click on a part number.

Attach these light duty hangers to ceilings and walls. They have a stiff wire for supporting suspended ceilings, lighting fixtures, and other lightweight material.

Threaded hangers have a pointed screw end for tapping into wood.

Screw-on hangers have an unthreaded hole for mounting with a fastener.

For technical drawings and 3-D models, click on a part number.