Tap a wire or add a finished terminal to the end of a wire. Crimp the parallel tap onto the line you wish to tap, and insert the snap plug into the parallel tap. Parallel tap and snap plug are sold separately.

Tap and splice multiple wires together at the same time. Insert your main wire into a port and each tap wire into the other ports before tightening the screws. All are fully insulated with PVC. UL listed, they meet U.S. safety standards.

For splices with through holes, one side of each port must remain open.

Splices with plastic plugs cover the screw openings to keep contaminants out. Splices with through holes and plastic plugs let you close entry ports that aren’t in use.

Use black, blue, and clear splices with Class B and C stranded wires. Clear splices help you confirm the connection visually.

Use gray splices with Class B, C, and D stranded wires.

Splices that are C-UL listed meet Canadian safety standards.

For technical drawings and 3-D models, click on a part number.

Tap and splice multiple wires in temporarily wet environments and up to six feet underground. Made with an EPDM rubber housing, these splices are fully insulated. Trim-to-size wire port plugs create a tight seal for wire entry, and removable screw-in plugs with double O-rings tightly seal the screw openings. All are UL and C-UL listed as meeting American and Canadian safety standards. These splices are for use with Class B and C wire types.

Splice large wire sizes without special tools—insert your wires and tighten the hex nut to make a connection. The hex nut can be loosened to disconnect if needed.

For technical drawings and 3-D models, click on a part number.

No crimping or wire stripping needed—this assortment includes twist-on wire connectors and insulation-piercing wire taps.