Wire Gauge Wire Gauge |
|---|
|
Outer Insulation Color Outer Insulation Color |
|---|
 | Black |
Wire Type Wire Type |
|---|
 | |
System of Measurement System of Measurement |
|---|
|
Voltage Voltage |
|---|
|
Flexibility Flexibility |
|---|
 |
| Continuous Flex |
 |
| Flexible |
Shielding Shielding |
|---|
 | Unshielded |
 | Double Shielded |
Use For Use For |
|---|
|
Specifications Met Specifications Met |
|---|
|
Wire Material Wire Material |
|---|
|
Wire Finish Wire Finish |
|---|
|
Current Current |
|---|
|
Maximum Temperature Maximum Temperature |
|---|
|
Cable AWG Cable AWG | Show |
|---|
Inner Insulation Marking Inner Insulation Marking |
|---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
|---|
Inner Insulation Material Inner Insulation Material |
|---|
|
Outer Insulation Material Outer Insulation Material |
|---|
|
Inner Insulation Color Inner Insulation Color |
|---|
 | Black |
 | Green/Yellow |
About Wire and Cable
More
No-Conduit-Required Control Cable
- Use For:
Unshielded: Automation
Double Shielded: Automation, Interference Shielding - Flexible
- Temperature Range: -10° to 190° F
- Insulation:
Outer: PVC Plastic
Inner: Nylon/PVC Plastic Blend
This cable meets TC-ER crush and impact requirements for exposed runs in cable carriers, so it can be used without conduit. It withstands period flexing and bending, sends signal and data to operate, measure, or regulate automated equipment. The PVC insulation resists oil. It’s flame rated FT4 to meet requirements for preventing the spread of flames based on a timed test with material mounted to a vertical tray.
Use unshielded cable in applications where signal interference is not a concern.
Double shielded cable has a layer of braid and foil shielding that provides excellent protection against signal interference from nearby equipment and devices.
MSHA approved cable meets Mine Safety and Health Administration (MSHA) standards for material quality.
Per Ft. | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Wire Ga. | No. of Wires | Cable AWG | Current | OD | Outer Insulation Color | Inner Insulation Color | Industry Designation | Specifications Met | Length, ft. | 1-99 | 100-Up | |
Unshielded Stranded Wire | ||||||||||||
600V AC | ||||||||||||
| 12 | 7 | 12/7 | 16 A @ 86° F | 0.58" | Black | Black, Green/Yellow | TC-ER | UL Listed, C-UL Listed, Flame Rated FT4 | 0000000 | 00000 | 00000 | |
Double-Shielded Stranded Wire | ||||||||||||
600V AC | ||||||||||||
| 12 | 7 | 12/7 | 16 A @ 86° F | 0.61" | Black | Black, Green/Yellow | TC-ER | UL Listed, C-UL Listed, MSHA Approved, Flame Rated FT4 | 0000000 | 0000 | 0000 | |
Oil-Resistant Continuous-Flex Cable
This cable has an insulation with excellent resistance to oil, so it can be used near motors and equipment that require oil lubrication. Often used in automated applications such as robotics and cable carriers, it withstands continuous motion without degrading data or signal transmission. It’s flame rated VW-1 to meet requirements for preventing the spread of flames based on a timed test with vertically suspended material.
Use unshielded cable in applications where signal interference is not a concern.
Bend radius is the point to which the cable will bend without being damaged. It is measured from the center of the bend to the edge of the cable. The smaller the measurement, the tighter the bend.
- Use For: Automation, Continuous Motion
- Continuous Flex
- Insulation:
600V AC: PVC Plastic Inner Insulation
1,000V AC: TPE Rubber Inner Insulation
See Table for Outer Insulation - Environment:
600V AC: Not Rated
1,000V AC: Clean Room - Specifications Met:
600V AC: UL Recognized Component, CSA Certified, Flame Rated VW-1
1,000V AC: UL Recognized Component, C-UL Recognized Component, Flame Rated VW-1
V-Belts
