Wire Gauge Wire Gauge | Show |
---|
System of Measurement System of Measurement |
---|
|
Length Length |
---|
|
|
|
Flexibility Flexibility |
---|
![]() |
Continuous Flex |
![]() |
Ultra Flexible |
![]() |
Flexible |
![]() |
Bend and Stay |
Wire Type Wire Type |
---|
![]() | |
Use For Use For |
---|
|
Current Current |
---|
|
Wire Material Wire Material |
---|
|
Shielding Shielding |
---|
![]() | Unshielded |
![]() | Shielded |
Wire Finish Wire Finish |
---|
|
Maximum Temperature Maximum Temperature |
---|
|
Minimum Temperature Minimum Temperature |
---|
|
RoHS (Restriction of Hazardous Substances) RoHS (Restriction ofHazardous Substances) |
---|
|
Specifications Met Specifications Met |
---|
|
DFARS (Defense Acquisition Regulations Supplement) DFARS (Defense AcquisitionRegulations Supplement) |
---|
REACH (Registration, Evaluation, Authorization and Restriction of Chemicals) REACH (Registration,Evaluation, Authorization and Restriction of Chemicals) |
---|
|
About Wire and Cable
More
Building Wire
- Use for buildings
- Stranded Wire: Flexible
Solid Wire: Bend and Stay - Temperature Range:
Wire with Nylon Outer Insulation: -10° to 190° F
Wire with Polyethylene Outer Insulation: -40° to 190° F
Install this wire in conduit and cable trays in commercial and industrial buildings. It's also known as branch circuit wire.
Stranded wire is flexible, so it’s pliable enough to be pulled around corners. Wire with a nylon outer insulation resists oil and water. THHN wire can be used in dry or damp locations where wire is exposed to condensation or moisture, such as a basement. THWN and THWN-2 wire can be used in both wet and dry environments.

Wire Ga. | Strand Count | Current | OD | Industry Designation | Specifications Met | Choose an Outer Insulation Color | Length, ft. | Per Ft. | |
600V AC/600V DC | |||||||||
---|---|---|---|---|---|---|---|---|---|
2/0 | 19/12 | 195 A @ 86° F | 0.52" | THHN, THWN-2 | UL Listed | 0000000 | 00000 |
Battery Wire

- Use for vehicles
- 60V DC Wire: Flexible
600V AC/DC: Ultra Flexible - Temperature Range: -40° to 190° F
Connect batteries in vehicles and generators.
Strand count is the number of strands followed by the size of the individual strand.
Wire with a PVC plastic insulation resists fuel and oil.
Wire with an EPDM rubber insulation is ultra-flexible for use in applications that require tight turns. The insulation resists abrasion and oil.
SAE J1128 and SAE J1127 wire meet standards for low-voltage wiring in vehicle electrical systems.
Per Ft. | |||||||||
---|---|---|---|---|---|---|---|---|---|
Wire Ga. | Strand Count | Current | OD | Specifications Met | Choose an Outer Insulation Color | Length, ft. | 1-99 | 100-Up | |
Stranded Wire with PVC Plastic Insulation | |||||||||
60V DC | |||||||||
2/0 | 133/20 | 233 A @ 86° F | 0.61" | SAE J1127 | 0000000 | 000000 | 00000 | ||
Stranded Wire with EPDM Rubber Insulation | |||||||||
600V AC/600V DC | |||||||||
2/0 | 1,254/30 | 300 A @ 86° F | 0.59" | __ | 0000000 | 0000 | 0000 |
Outdoor Wire

- Use for outdoors, buildings, power supply
- Flexible
- Temperature Range: -55° to 220° F
- Insulation: EPDM Rubber
Protected by an EPDM insulation that resists UV light, water, abrasion, and oil, this wire is often used outdoors in lighting and generators. It’s flame rated FT5 to meet requirements for preventing the spread of flames based on a timed test with material that is horizontally suspended and heated before being exposed to flame.
Oil-Resistant Continuous-Flex Cable
This cable has an insulation with excellent resistance to oil, so it can be used near motors and equipment that require oil lubrication. Often used in automated applications such as robotics and cable carriers, it withstands continuous motion without degrading data or signal transmission. It’s flame rated VW-1 to meet requirements for preventing the spread of flames based on a timed test with vertically suspended material.
Shielded cable has a layer of braid that blocks signal interference from nearby equipment and devices.
Bend radius is the point to which the cable will bend without being damaged. It is measured from the center of the bend to the edge of the cable. The smaller the measurement, the tighter the bend.


- Use For: Shielded: Automation, Continuous Motion, Interference Shielding
- Continuous Flex
- Insulation:
600V AC: PVC Plastic Inner Insulation
1,000V AC: TPE Rubber Inner Insulation
See Table for Outer Insulaton - Environment:
600V AC: Not Rated
1,000V AC: Clean Room - Specifications Met:
600V AC: UL Recognized Component, CSA Certified, Flame Rated VW-1
1,000V AC: UL Recognized Component, C-UL Recognized Component, Flame-Rated VW-1
Per Ft. | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Wire Ga. | No. of Wires | Cable AWG | Current | Temp. Range, °F | OD | Bend Radius | Outer Insulation Material | Outer Insulation Color | Inner Insulation Color | Environmental Rating | Length, ft. | 1-99 | 100-Up | |
1,000V AC | ||||||||||||||
2/0 | 4 | 2/0/4 | 239 A @ 86° F | 25° to 155° | 1.85" | 12.68" | PVC Plastic | Black | Black, Green/Yellow | ISO Class 2 | 0000000 | 000000 | 000000 |
Welding Cable



- Use For: Welding
- 600V AC: Bend and Stay
600V AC/DC: Flexible - Temperature Range: -55° to 220° F
- Insulation: EPDM Rubber
This cable withstands abrasion, oil, and the rough conditions found in welding applications. It’s flame rated VW-1 to meet requirements for vertical flame testing.
Class K cable is for general purpose welding applications. It bends and stays in the position that you bend it.
Class M cable is more flexible and durable than Class K cable.
Flame-Resistant Welding Cable


- Use For: Outdoors, Welding
- Flexible
- Temperature Range: -55° to 190° F
- Insulation: Polyethylene Plastic
This cable meets Mine Safety and Health Administration (MSHA) standards for flame resistance. It’s also flame rated VW-1 to meet requirements for preventing the spread of flames, based on a timed test with vertically suspended material. The insulation resists abrasion and chemicals.
Battery Power Cords
Connect batteries to each other.
Clamp × lug and lug × lug cords also connect batteries to electrical systems.
Cords with post terminals or threaded stud terminals connect two or three batteries in parallel for maximum starting power. Connect the positive terminals together and the negative terminals together to get the combined capacity (in amp-hours) of the batteries—battery voltage remains the same.

Cord | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Wire Gauge | Lg. | Lug ID | End Shape | OD | Insulation Material | Connection Material | Temp. Range, °F | Choose a Color (Polarity) | Each | |
2/0 | 10" | 3/8" | Straight | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 000000 | |
2/0 | 20" | 3/8" | Straight | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 | |
2/0 | 30" | 3/8" | Straight | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 | |
2/0 | 60" | 3/8" | Straight | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 |


Cord | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Wire Gauge | Lg. | End Shape | Lug ID | OD | Insulation Material | Connection Material | Temp. Range, °F | Choose a Color (Polarity) | Each | |
2/0 | 10" | Straight | 3/8" | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 000000 | |
2/0 | 20" | Straight | 3/8" | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 | |
2/0 | 30" | Straight | 3/8" | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 | |
2/0 | 60" | Straight | 3/8" | 0.61" | PVC Plastic | Tin-Plated Copper | -40° to 220° | 00000000 | 00000 |

Cord | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
Wire Gauge | Lg. | Lug ID | End Shape | OD | Insulation Material | Connection Material | Temp. Range, °F | Choose a Color (Polarity) | Each | |
2/0 | 6 13/16" | 3/8" | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 000000 | |
2/0 | 7 3/8" | 3/8" | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 00000 | |
2/0 | 14" | 3/8" | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 00000 |

Cord | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Wire Gauge | Lg. | Lug ID | Stud Thread Size | End Shape | OD | Insulation Material | Connection Material | Temp. Range, °F | Choose a Color (Polarity) | Each | |
2/0 | 6 13/16" | 3/8" | 3/8"-16 | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 000000 | |
2/0 | 7 3/8" | 3/8" | 3/8"-16 | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 00000 | |
2/0 | 14" | 3/8" | 3/8"-16 | 90° Elbow | 0.61" | PVC Plastic | Lead | -40° to 220° | 000000 | 00000 |
